Metallurgy
How to apply magnetic field parallel to b axis of any crystal
29 July 2024 4,083 2 View
I have been running a MAGeCK test command on the terminal for a CRISPR screen to rank sgRNAs and genes based on the read count tables. However, I get only the plot of the top-ranked genes...
28 July 2024 9,811 1 View
I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...
22 July 2024 3,490 2 View
How can I define Planetary motion in ABAQUS CAE, how define motion of three rollers around a central axis and passive rotation about their own axis?
16 July 2024 4,145 1 View
I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...
16 July 2024 3,212 5 View
I am working on powder metallurgy, and during the compaction process, the powder does not pelletize and remains in its powder form. To address this issue, I am considering using binders to improve...
13 July 2024 9,003 2 View
In terms of CFD, we often analyze the stability of the error using Von-Neumann analysis, especially for FDM based problems. Should we follow the same approach for a compressible fluid flow using FVM ?
13 July 2024 6,296 5 View
I am preparing polycrystalline diamond (PCD) with tape casting. The powder is 8~12 um. After drying of tapes, I place several tapes in Ta cup without warm-pressing. Next, debinding is carried...
23 June 2024 7,758 2 View
How can I change marker axis line type to dotted in 1D Results/S-Parameters in CST Studio Suite?
10 June 2024 9,828 0 View
Good morning, I am running some Steered molecular dynamics in Amber 22 and want to set some restraints in the z-axis so as to imply certain distances from my ligand to its substrate. My goal is...
27 May 2024 7,082 1 View
