How to normalise data on OPM package from R Studio ?

Good afternoon, I recently used OmniLog from BIOLOG for my experimentations : I tested the metabolism of different strains on 2 types of plates. I have 16 strains of 3 different groups...

02 March 2021 3,584 1 View

Which is the most convenient manufacturing software for Additive Manufacturing?

Which tools can be used to generate machine codes for additive manufacturing?

02 March 2021 7,220 2 View

How to plot the probability paper of Gumbel distribution using R programing?

In R-studio, there are many commands of Gumbel package. Arguments are also different. I`m asking about the alpha parameter of the Copula which must be greater than 1. If this is the one used to...

25 February 2021 5,229 3 View

Has anyone had luck using cell lines other than HEK 293 (such as COS1) to package lentivirus?

I am looking to package lentivirus in endothelial cells but I am opposed to using 293 cells due to personal ethics regarding the source. I have done some reading and saw that COS1, COS7, & CHO...

25 February 2021 3,030 1 View

No title

25 February 2021 5,713 1 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

Is anyone working on a project focused on immigrants/newcomers working in the hospitality industry and how they have been impacted by COVID?

The on-going Covid-19 pandemic has had devastating economic effects on many industries. However, few have suffered to the same extent as full-service restaurants. Numerous studies have shown that...

24 February 2021 9,496 4 View

Implementation of chance-constrained optimization problem via scenario approach?

23 February 2021 7,826 2 View

What is the optimum time and temperature of blanching and pre-frying potato for frozen fries?

I am helping a local home industry for developing frozen fries from their local farm. I want to know what is the optimum blanching and pre-frying temperature and time for processing. Please also...

23 February 2021 1,616 5 View

Fictitious Boundary Meshing Method (FBM) in Commercial FEA software?

Is it possible to implement FBM in a commercial FEA software package, such as FEMLAB, COMSOL, or open source software like Moose?

22 February 2021 2,968 1 View