Is there 6 absorbers in the Nixtox Box Adsorbers diagram?

More Md Badriadib Aldrin Suhaini's questions See All

Develop operating envelope?

how do you develop an operating envelope for a solar compressor? what data I need and how do I know the operating envelope would be "perfect"? I have never done anything on operating envelope,...

04 May 2017 6,541 1 View

How do you reflect on a book?

how do you reflect on a book? I usually just close the book and give some thoughts to it but i feel like its not effective way to reflect by just giving thoughts. What are your suggestions? How do...

07 August 2016 9,268 4 View

Can I thank the people who have helped and gave me answers to my questions?

I would like to say thank you to all of you who have helped me so far with my thesis on the movement and concentration of suspended particles in the nodal planes of an ultrasonic standing wave...

05 June 2016 8,799 1 View

How do I get an 80 mark and above on writing a dissertation/thesis project?

I have finished my literature review and I have finished the draft of my numerical simulation(or you could say my own project). What is left is to 'beautify' my dissertation more. How do I get a...

04 May 2016 3,600 2 View

Look into my acoustic pressure field, does it look like having an acoustic streaming?

Why is it that in the middle there are no standing wave field?How will the particles move when the standing wave field is only on the upper and lower of the cavity?

03 April 2016 4,757 5 View

Why are the particles concentrated in the nodal planes for only a period of time?

As you can see from the attached diagram, the particles are concentrated in the nodal planes at 0.008 s. But at 0.1s, the particles are not as concentrated in the nodal planes as at 0.008 s ( i.e....

03 April 2016 4,523 9 View

How much nitrogen is required for regenerating a vapour phased carbon bed adsorption?

I only know that for steam regeneration, I need 3 to 5 kg of steam per organic removed. But what about nitrogen regeneration? How much flow rate or mass is needed per organic removed?

03 April 2016 4,906 3 View

What can you deduce from my 1D plot graph of the mass fraction of suspended particles in a standing wave field?

The y-axis shows the mass fraction of the suspended particles and the x-axis shows the length of the cavity. When x = 0, that is to the left end wall of the cavity, when x = 21, that is at the...

03 April 2016 7,931 2 View

For the COMSOL simulation of particle manipulation using ultrasonic standing wave, why is the resonant freq. different at different mesh sizes?

I have attached two diagrams, one is for an extra-fine mesh and the other is for an extremely fine mesh. I am using PZT-4D and my suspended particles are polystyrene particles in water. The...

03 April 2016 4,662 3 View

Why are my 1D and 2D plot results look different [COMSOL, ultrasonic standing wave on suspended particles]?

As you can see from at 0.013 and 0.02s,the 2D plot graph does not show any changes but from the 1D plot graph, it shows changes. Why is that so? Both plot shows the changes to the mass fraction...

03 April 2016 9,112 2 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

What is the best method to detect the chemical composition of pollen ?

I have multiple small samples of grass pollen with anthers. I want to find a method to identify concentrations of proteins, lipids, and other various elements for these samples. any suggestions?

28 July 2024 5,331 1 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

What topic or subject does Production Engineering need to address more?

Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?

27 July 2024 648 3 View

Can a shoot-through event of a tri-state digital buffer cause momentary Hi-Z state?

// interested in the difference between floating events and short circuits.

22 July 2024 6,565 0 View

Is there a good macro photography kit for on-site metallurgical investigation?

I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...

22 July 2024 3,490 2 View

Hi dear researchers, do you suggest the best and shortest path for chemical synthesis and green synthesis of magnetite(Fe3O4)?

Suggest the best and shortest route for the chemical synthesis and and green synthesis of magnetite(Fe3O4) The chemical synthesis should contain the least dangerous chemicals along with full...

21 July 2024 2,476 2 View

Why do fish have fishy odors naturally ?

Chemical Engineering /Food Engineering

20 July 2024 4,152 4 View