I would like to estimate the effective viscosity and thermal conductivity of the superalloys inside the meltpool. Please let me know if any database/standard/method is available for it
please check paper by K. C. Mills,
I have a theoretical framework for preparing a interview guide to assess the unmet care needs of a sub population of chronically ill patients and their caregivers(dyadic interviews).
04 August 2024 8,798 7 View
There are 33 items adding up to an overall value for qol score. How to present the results of two-step cluster analysis in the methodology for differentiating cases and controls group? Should any...
14 May 2024 7,717 2 View
Since Research fundings are always limited in most countries, is it a good idea to set up crowdfunding? Thanks
31 March 2024 7,333 0 View
I downloaded QCADesigner 2.0.3 tool. but i am not able to open simulation type set up. once i click on that option entire window suddenly goes on ..Please help me to solve the issue
06 December 2023 853 1 View
I saved the waveform from QCADesigner tool with an extension of .EPS. But when I open the file in EPS viewer it is not opened and EPS window suddenly closed. Is the way correct to open a file in eps
06 December 2023 559 2 View
Answer
14 September 2023 2,271 1 View
INTERNAL CORPORATE SOCIAL RESPONSIBILITY MODEL TO INCREASE ORGANIZATIONAL PERFORMANCE IN MALAYSIAN PRIVATE HIGHER EDUCATION INSTITUTIONS IN KLANG VALLEY, MALAYSIA Based on the above topic, what...
13 July 2023 7,692 2 View
I'm not able to reach Professor Reynolds directly and none of the authors of the papers that have used his scale have replied to my emails. If anyone has used this scale then please let me know if...
12 July 2023 7,621 2 View
Hi everyone. I have LC-MS/MS data and the trial version of the Bruker compass data analysis software. I need to identify certain compounds in the chromatogram. Doing so manually is proving to be...
30 May 2023 8,087 0 View
Ethics approval for questionnaire validation study
11 May 2023 8,439 5 View
i am unable to interpret why its increases in start as shown in figure
11 August 2024 2,179 1 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,493 1 View
I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.
09 August 2024 9,894 2 View
Some sources say it is treated as Newtonian as ethylene glycol has a higher viscosity than water, which affects the flow characteristics in simulations. But some also say it is non-Newtonian.
09 August 2024 2,111 2 View
I am puzzled about the properties of gelatin, when used for tissue-embedding. Hard gelatin can be melt again by temperatures about 40°C. Formalin-fixed gelatin is like crosslinked protein and...
07 August 2024 1,686 1 View
I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...
07 August 2024 5,177 3 View
Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...
06 August 2024 1,989 3 View
I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...
05 August 2024 3,290 1 View
I am currently using CASTEP version 2020. When I want to run optical properties calculations with spin-orbit coupling(SOC), I encounter the following error in a pop-up window before the job gets...
02 August 2024 2,890 0 View
Do these peaks in the curve indicate primer dimer or non-specific products?
01 August 2024 7,466 0 View