Oxidation of Al2O3-forming alloys
Thank you Reddy for your reply. It seems you misunderstood my question.
Volker, thank you so much for your precious comments and helpful suggestions, as usual
We use reactive sputtering process to make aluminum nitride film, and want to make c-axis aluminum nitride film on a silicon substrate, but the crystal orientation cannot be seen with...
03 March 2021 7,975 3 View
Which solution reveals the microstructure and features of nickel-based alloys?
02 March 2021 2,221 3 View
(This statement is from wikipedia, BTW). What is so special about metallic bond that is limiting high-P low-T state of a matter (as long as individual atoms exist, not white dwarf of neutron star...
02 March 2021 3,309 2 View
Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.
28 February 2021 3,640 3 View
I am trying to analyze lipase using the reverse phase-HPLC C18 column. In the literature, 0.1 % TFA was and 60% ACN was used. Can I use TCA in place of TFA? If any other methods are available to...
25 February 2021 2,388 3 View
i am trying to download x'pert high score software, but can't download it. please do suggest software for phase analysis
24 February 2021 5,687 4 View
For wrought alloys soaking time at solutionizing temperature is determined by thickness .Do we have such standards for cast Al alloys
23 February 2021 8,839 3 View
Hi, I know the attached Txy diagram has an error but can't figure it out. Could you please look at the diagrams and explain it to me?
23 February 2021 4,239 1 View
I notice that upon washing and air-drying of my RGO/SPCE surface and characterizing again via DPV, the current response towards ferricyanide probe significantly decreases. My worry is that the...
22 February 2021 5,324 3 View
I have prepared Ag-Cu alloy with polymer coating upon it.... how can I measure thermal conductivity of it ?
22 February 2021 5,915 3 View