I am doing modelling of the piezoelectric sensor in Ansys workbench but unfortunately, I am unable to find any help regarding it. There are many helps given for same work in ansys apdl, so I was thinking if I can convert ansys apdl results or work into Ansys workbench and vice versa. A reply would be appreciated. I would be thankful if I get help from anywhere in the world.
Dear Aditya Parpe , we can open ANSYS APDL File in Workbench & Vice versa. When we can open a file with other format we can save it with now format. See the following link.
https://www.youtube.com/watch?v=XSYRnEfPMqA
Thank you Ouaïl Ouchetto for letting me know about this. Very informative.
Dear Mr. Aditya
My opinion you have to write the code by using APDL, then you can importing the APDL file into Workbench as new format and more easy to use it, the link as below:
https://m.youtube.com/watch?v=k_Re2Tya_Ic
Good luck
Thank you Norie Allafi Akeel sir for the help. I will implement the same.
- Badges
- Science topic
- Similar topics
- Engineering
- Modeling