I am preparing a thin layer through the sol-gel method.
See these links,
It may help you.
Paper: Solubility of Zinc Sulfide in Molten Halide Salts.
Links: http://encyclopedia2.thefreedictionary.com/Zinc+Sulfide
http://www.nist.gov/data/PDFfiles/jpcrd444.pdf
Zinc silfide solubles in water at high temperature. Below references may helpful to you.
Economic Geology 1959 54:1035-1039
Yes, I dissolved with strong acid HNO3, But it converted into zinc nitrate. What I required is to save the original ZnS in solution form.
one way to redissolve zinc sulfide is performed by addition of EDTA in the solution. since, EDTA acts as a strong ligand to bind Zn2+ ions and release sulfide anions.
I took XRD of my compound, It has three peaks. I have to calculate the hkl values for them. I calculated the 'd' for Bragg's Equation for all three peaks. I do not know the lattice parameter(a) of...
05 June 2016 4,582 5 View
I am building solar similator at my laboratory. I used tungsten source which is giving only 12000 lux. I am looking for a source of 100,000 lux or so. Please suggest me.
10 November 2015 7,463 7 View
With the help of UV- Visible Spectroscopy I got band gap. But I do not understand how to calculate HOMO and LUMO. Please tell me how to calculate this.
31 December 2014 8,624 2 View
I am trying to electrochemically deposit previously synthesized polyaniline blended with manganese doped zinc sulphide. Is there any way to do so or do I have to synthesis polyaniline...
11 December 2014 3,367 5 View
Other than solgel and spin coat method.
08 September 2014 8,191 9 View
I was looking for the XRD peak of Mn Doped ZnS in The International Centre for Diffraction Data (JCPDS). But I could not get how to extract the data required.
11 December 2013 3,123 11 View
A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...
11 August 2024 9,801 2 View
I need to do some experiment with it in liquid form.
07 August 2024 613 3 View
How can I measure the thickness of thin film by Uv-Vis?
06 August 2024 7,810 3 View
I have been working on Red blood cell-derived extracellular vesicles as Antisense Oligonucleotide (ASO) carriers. We normally run agarose gel to quantify the loading efficiency. I used naked ASO...
06 August 2024 3,130 2 View
Are there any statistical methods to justify your sampling technique using SPSS or AMOS?
05 August 2024 9,153 4 View
Better ways to analyze the qualitative and quantitative data in a sequential explanatory mixed method approaches
04 August 2024 2,703 6 View
I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...
03 August 2024 4,725 2 View
Why is TLC not a form of partition chromatography and paper chromatography not a form of absorption chromatography?
03 August 2024 7,035 3 View
Hello everyone, I need to dissolve stigmasterol for an animal experiment, but it hasn't dissolved in either DMSO or vegetable oil. Can anyone recommend the best solvent for stigmasterol?
01 August 2024 7,504 2 View
It's an end-point PCR protocol. I'm using 1.5% agarose gel with SyBR Safe dye and TBE as a running buffer, visualization on BioRad XR+ system. I was primarily thinking of primer efficiency,...
01 August 2024 4,673 4 View