In UV calibration for dye concentration measurement, is it necessary to capture all concentration range e.g. If the range is 20 to 200 mg/L ?

07 July 2018 0 3K Report

Is it compulsory to prepare standard concentration up to 200 mg/L or one can stopped at 100 mg/L

Badges
Science topic

More Abel A. Adeyi's questions See All

What is the relationship between Langmuir adsorption capacity qmax (mg/g) and the molecular mass of adsorbate (e.g. dyes)?

The Langmuir adsorption capacity of dye 1 is higher than dye 2, while the percentage removal of dye 2 is a bit higher than dye 1. Though, the molecular mass of dye 1 is higher than dye 2. So, I...

04 May 2019 9,490 13 View

Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

Baseline drift in HPLC? What causes this?

Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!

11 August 2024 3,770 4 View

U you think We need a website software of Blackbody radiation law expert software?

A website software of Blackbody radiation law expert software can used through the following web site. http://39.105.188.151:3000/index

07 August 2024 1,706 0 View

Could dyes amplify the spectrum of light to a specific wavelength?

I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...

05 August 2024 3,290 1 View

Can a Conventional 50W visible LED Lamp Emit UV Light?

I'm researching light sources and their UV emissions. I'm curious if a 50W, 7500K conventional LED lamp emits any UV light. I found that a 200W tungsten lamp can emit up to 1.5 mW/cm² at 350 nm....

31 July 2024 3,843 7 View

How can we calculate the percentage of configuration interaction (CI) in the UV output data of the Gaussian program?

How can we calculate the percentage of configuration interaction (CI) in the UV output data of the Gaussian program? for example: Excited State 17: Singlet-A 5.1359 eV 241.41 nm...

28 July 2024 9,165 2 View

What does negative readings in spectrophotometer denote. Was testing TSS content of bacterial cultures?

I was performing estimation of Total Soluble Sugar content in bacterial cultures by Anthrone method. Out of 9 samples, only one sample showed positive reading while others had a negative reading...

22 July 2024 9,576 4 View

Waht is the effect of isoelectric point on MB dye photodegradation by ZnO nanoparticles?

Recently I have submitted an article regarding MB dye degradation by ZnO nanoparticle. I received a suggestion to include the discussion on the effect of pH. I want to know what is the impact of...

19 July 2024 4,868 1 View

How to find ECC from radiation pattern on cst ?

i need to find ECC for 4-MIMO antenna using radiation pattern on CST

16 July 2024 7,291 1 View

Help me to identify these fungal slides?

These fungal slides are isolated from cultured Bread mold on PDA media and smear is treated with Lacto phenol Blue dye ..

13 July 2024 9,701 1 View