Usually, you would be given a number. Say power consumption P, use DET if the power higher than P, and use PPT otherwise. It is too general to justify the selection.
Is there any detail study on this?
Thank you.
Herman Fernández
Hello
Please review the paper titled:
Parallel power processing topolgy for solar PV applications. Ieee Trans. Ind. App., Vol50, No.2. Mohamed Badaway et al.
0 votes
0 thanks
Sri Harsha Pavuluri
Hello,
You can refer to the book
Spacecraft Power Systems by Mukund R Patel
You can also refer to the attached publication for more information about power system design. This paper presents the design of our satellite's power system.
Conference Paper Electrical Power System of SRMSAT -2
0 votes
0 thanks
- Badges
- Science topic
More Wang Xiaoliang's questions See All
Similar questions and discussions