In an oxy-acetylene ablation test, how to adjust the pressure readings of oxygen and acetylene cylinders to get a heat flux of 835 W/cm sq. ?

12 December 2018 0 5K Report

The nozzle diameter of torch is 1 mm. The volume ratio of oxygen to acetylene should be 1.20 according to ASTM standard for oxy-acetylene test.

Badges
Science topic

Similar topics
Thermodynamics
Pressure

More Ali Anjum's questions See All

Can anyone tell me the formula for estimation of thiamine content in plant extract after measuring the absorbance?

I need the formula for estimation of thiamine content in plant extract after measuring the absorbance? If thiamine standard curve is needed then how can that be constructed?

05 June 2018 1,695 2 View

How to fix errors in my heat transfer steel structure with reinforced concrete slab model Abaqus?

I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...

07 August 2024 1,028 0 View

Why do i have a weak plasma and no coating during rf sputtering?

I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.

07 August 2024 4,526 4 View

Aspen Plus Simulation?

Greetings When one is to perform Simulation or modelling of Pyrolysis of Biomass Waste materials using Aspen Plus software, and one has both the macromolecules breakdown (Cellulose, Lignin and...

06 August 2024 5,023 1 View

Why does my protein refolded to beta sheet during thermal denaturation analysis?

Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...

06 August 2024 1,989 3 View

How to assess the osmotic power of a substance?

Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...

06 August 2024 977 1 View

How to heat polymer for about 130° without oil bath ?

is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it

06 August 2024 947 1 View

Why results of ROS flurescence are negative as there was no bacteria within?

Hello. I am working on ROS production of two systems: system A is cerium oxide and hydrogen peroxide, system B is cerium oxide nanoparticle, hydrogen peroxide and potassium bromide. I did some...

04 August 2024 5,974 3 View

What should I do with parameters that are not relate to my simulation in MyLake model?

I want to Estimate surface heat fluxes using MyLake, but I don't have all the initial values in model parameters section and other sections,is there a way?

04 August 2024 1,537 1 View

Why aren't most metal oxides insoluble in water?

Why BaO (s) + H2O(l) ---> Ba 2+(aq) + 2 OH - (aq) if Oxygen loves owning all the electrons, why would it bind to hydrogen which competes with Oxygen for electron ownership more so than...

03 August 2024 5,392 1 View

How to Transform my handy-wavy explanation of why group I/II metals oxides in aqueous solution are basic into a rigorous argument?

I heard an explanation about something being a better proton acceptor or lone pair donor but that doesn't make sense. I couldn't explain in in terms of acid-base theory. The hand-waving way I saw...

03 August 2024 9,918 0 View