Hi
I want to Do Buckling Analysis a thin walled cylindrical steel reservoir. I want know,How can i use first mode for initial imperfection? I don't know that how can i apply imperfection? Are there any Command to do this?
Hi everyoneI have a 3D model(concrete slab)in ansys(Apdl),this model is built directly as a mesh(just node and element,no line,area and volume).i want to simulate the free fall of steel ball in...
07 August 2017 9,661 1 View
Hi my friendsI made a model of circule concrete column in APDL (with Solid65). how can i meshing this column as same as picture? is it compatible this method with solid65?thanks.behzad.
05 June 2016 5,596 3 View
Dear my friendsI modeling a concrete connection in Ansys Mechanical APDL,that picture’s attached. In this model the column was subjected to a constant axial load equal 305 Kn and monotonic...
04 May 2016 3,143 6 View
I would like to learn more about SPSS and Its application especially in regards to data analysis. Please suggest me how I can learn more about it. Thank you so much.
11 August 2024 9,101 4 View
I have reverse sequences (AB1 format), can I base on reverse DNA sequences to perform nucleotide alignment, convert nucleotides to amino acids and deposit the sequence in GenBank database?
11 August 2024 5,138 1 View
Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!
11 August 2024 3,770 4 View
Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...
10 August 2024 7,180 0 View
I'm currently exploring the application of Python in textile engineering, specifically in areas like data analysis, process automation, and the development of smart textiles. I'm interested in...
10 August 2024 7,429 2 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...
07 August 2024 1,937 1 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
I am experimenting with cancer and non-cancer cells in a 12-well plate for 4 days with a seeding density 1*10^4/well, however, I noticed that the control group growth rate slows down on D3. Should...
07 August 2024 2,283 2 View