If the moisture content is 80% and the total solids are 20%, the bio-oil yield is 0.334, and the Higher Heating Value (HHV) is 27.5 MJ/kg, then what will be the specific heat for fleshings in this case? While calculating with attached document, the value differs.

Is there any solution if I have the specific heat for fleshings at another moisture content, and also for tannery wastewater, then how will the specific heat be at another moisture content?

K is TFW (Fleshings waste), 3.6 kJ kg−1 K−1) on Moisture content (MC) 82.57 ± 0.62

Total solids 17.42 ± 0.62 what K should be on MC 80% and TS 20%?

Article Valorization of textile sludge and tannery fleshing wastes t...

Article Co-liquefaction of swine manure and mixed-culture algal biom...