I made a mistake in indicating the co-author of my article. How can I fix this?

Does continues partial charging/discharging do any harm to the BESS performance and degradation?

For a grid connected BESS (lets say 100 MW/200 MWh system, LFP battery), if we charge the BESS in such a way that whenever we can access power from the solar that will charge the BESS. Hence it...

01 August 2024 9,903 7 View

How to Post-fix Mice pup's brains?

I need to Postfix mice brains. I slice the brains using microtome at 40 microns. These are Postnatal days 7, 11, 14, and 21. I am using half the brain for other analysis, so I need to fresh freeze...

31 July 2024 1,123 4 View

I am trying to find phonon, and when i run calculations, there is error ?

how to fix this error, from phq_readin : error # 1 DFPT with the Blochl correction is not implemented I am attaching my ph.in file.

23 July 2024 4,649 2 View

How to fix install package meta in R?

> library(meta) Error: package or namespace load failed for ‘meta’ in loadNamespace(i, c(lib.loc, .libPaths()), versionCheck = vI[[i]]): there is no package called ‘numDeriv’

18 July 2024 3,536 0 View

GIS (How can i fix when it appear in mines despite selecting WGSWGS 84 / UTM zone 38N?

I have a problem with geo-referencing a shape file. How can I fix it when it appears in mines despite selecting WGSWGS 84 / UTM zone 38N?

18 July 2024 2,696 1 View

Why in some wavelengths there are "overflows" in my Carbon dot UV-Vis Spectroscopy results(Emission segment)?

Hi everyone I have got this test in a fixed excitation and various emissions. In some wavelengths there are overflows which make the resulted analyze different from other carbon dots. Is it normal...

18 July 2024 4,244 2 View

Are my cells contaminated with mycoplasma?

I suspect my cells are contaminated with mycoplasma. I fixed the cells with 4% PFA and stained them with DAPI. Below is the image I obtained. I don't observe the typical small, rounded DAPI foci...

11 July 2024 7,786 3 View

How can I put small FWHM in CasaXPS?

I'm trying to fitting Cu Auger peak into various state (Cu0, Cu+, CuI etc..) In Cu0, one of the peak's FWHM is 0.84 but when I try to enter smaller value than 0.89, "input error" is occured. How...

02 July 2024 4,932 3 View

Any Green Solvents to dissolve PET near room temperature?

I need a PET + Solvent mixture to feed it to a fixed bed reactor for steam reforming.

30 June 2024 2,122 2 View

fluorescent imaging without fixatives?

How to store SDS-PAGE for fluorescent imaging without fixatives? I am running protein samples on SDS-PAGE that are tagged with fluorophores. If I place the gel in a destain solution of...

29 June 2024 8,720 1 View