You will have to open the simcoupler block from the file where PSIM is installed and then copy it into your simulink model.(Simulink ->Open-> DIrectory where PSIM is installed-> Lookfor PsimMOdule.mdl or Simcoupler.mdl
OR
just go the link and download it: http://www.psim-europe.com/psim_simcoupler.php
You will have to open the simcoupler block from the file where PSIM is installed and then copy it into your simulink model.(Simulink ->Open-> DIrectory where PSIM is installed-> Lookfor PsimMOdule.mdl or Simcoupler.mdl
OR
just go the link and download it: http://www.psim-europe.com/psim_simcoupler.php
Hello @Ali i am still facing some problem even i followed above method as guided by Muhammad Ahsan.. When i browse for schematic in simulink in simcoupler then matlab generate some error (i.e; Error while evaluating UIControl Callback). and i also can not see the separate block in simulink library for simcoupler. Please help me with this problem
when i attache the simulation file of PSIM in the simulink using simcoupler then it generates an error when i press apply button. Following is the error message:
Error using PSimDialog>CloseBtn_Callback (line 217) Error reported by S-function 'SimCoupler' in 'chop1q_ifb_simulink_r_13/chop1q_ifb_psim': PSIM Message: %1 is not a valid Win32 application.
Error in gui_mainfcn (line 95) feval(varargin{:});
Error in PSimDialog (line 42) gui_mainfcn(gui_State, varargin{:});
Error in @(hObject,eventdata)PSimDialog('CloseBtn_Callback',hObject,eventdata,guidata(hObject))
Please guide me with error gerated by Matlab. Thanks
Dear i am facing problem in simcoupler when i simulate the schematic in simulink it gives following error
Error reported by S-function 'SimCoupler' in 'simcoupler_model_psim_simulink/simcoupler_model_psim': PSIM Message: 1% is not a valid Win32 application.
If you are using the PSIM Time-Limited Version or a version that does not require a hardware key, from the PSIM directory, run the program “SetSimPath.exe”. This will set up the SimCoupler Module with the Matlab/Simulink, and will add the SimCoupler block into the Simulink library browser.
PSIM is for power electronics. I am not dealing with any power electronic circuits. Rather, am working on microelectronics, which is by Virtuoso Visualization tool of CADENCE, where one can simulate an analog circuit. I could see very few references for doing co-simulation of MATLAB & CADENCE. So, only I wrote here.