A queous Neem Exatract as corrosion inhibitor for mild steel in acidic media.
salam alaikum
it is possible using it depend on the solution pH, conc, Temp, and other factors.
Its extraction depend on conditions and hydrodynamics. If you have specific conditions i may answer in details.
Dear Prof. F. K. Matlub,
The conditions are as follows:
1- 1.0 M HCl aqueous solution
2- Temp. 303 K and also higher temperatures: 313, 323, 333, and 343 K
3- Time for 6 Hours.
4- The aqueous extract of 1 g dry Neem leaves (soaked in 70 ml at room temperature for one hour) and diluted to I.0 L that has 1.0 M HCl).
Dear Ibrahim
The main disadvantage of using plant materials as corrosion inhibitors is their instability; they are readily biodegradable as well as their purification and economic efficiency. In some cases, thermal stability is crucial
Regards
Suppose the electrocatalysis time is 8h
10 August 2024 5,677 2 View
Please Help Us Urgently
01 August 2024 711 1 View
"How has Leader Sheikh Hasina's government allegedly responded to student protests, including the reported killing of over 500 students, as well as arrests, custody, remand, and the involvement of...
29 July 2024 2,181 7 View
Bangor University, wales, Uk
27 June 2024 1,845 0 View
Japan
27 June 2024 5,893 0 View
Environment and GIs
25 June 2024 1,875 3 View
GIS
25 June 2024 6,236 1 View
energy projects
17 June 2024 5,648 3 View
renewables energy
17 June 2024 3,205 5 View
risk management
17 June 2024 3,963 2 View
I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...
10 August 2024 8,539 5 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.
07 August 2024 8,782 3 View
Palmitic acid presence in aqueous fraction
05 August 2024 8,624 4 View
Dear readers, Thanks for your attention. I am wondering about the health economic problem of quantifying the value of interventions which a) prevent, b) improve symptom profile and c) ultimately...
05 August 2024 3,246 1 View
I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...
03 August 2024 4,725 2 View
I am conducting a systematic review and meta analysis; as I am extracting data I realized there is a consort diagram that shows the number of patients from randomization till end of the study. So...
01 August 2024 9,993 3 View
99% pure ethanol was used for maceration also alternate methods along with the temperature and time to concentrate the extract can be specified
31 July 2024 5,113 4 View