Hello!
I would like to implement a VANET prototype in an Arduino or something similiar and I don't know how to start.
If someone could give me some advice on what do I need to start implementing the protocols and those kind of things, it will be very helpful.
Thanks in advance.
Please, check the following links:
http://www.it.uc3m.es/cjbc/papers/pdf/2014_sanchez_adhoc_varon.pdf
https://www.researchgate.net/post/Has_somebody_tried_to_create_a_real_VANET_by_using_Android_Smartphones
Hello, I am not sure if Arduino is able to provide low latency communication for decent range as its the main requirement for VANET. You may start with the interesting cheap board ESP8266, it has very good HOW TO USE documents.
https://github.com/esp8266/Arduino
Otherwise, start with the Alix or apu linux boards,
http://www.pcengines.ch/
Good Luck
You want to use Arduino because of it is easy to program. Arduino is a general platform, so you will also need a wireless comm daughter board. Identify which of them provides you the best specs and then just try to connect two devices, one as transmitter other as receiver. After do this, start to configure this simple system doing either transmission and reception, basic physical layer. Then, continue implementing the protocol stack step by step. Check everything twice and DO not remove any SW that works, just make a backup by the way...
Good luck
- Badges
- Science topic
- Similar topics
- Engineering
- Computer Engineering