10 November 2021 3 3K Report

Molar ratio in bivariate plots of Na+-normalized Ca, how to plot this graph?

More Arif Ullah's questions See All
Why is electronic energy 0.000 for liquid crystal compounds and is invariable with temperature in Guassian 09 software?

Are there any suggestions or insights you can provide to help address this problem

06 August 2024 1,443 2 View

How to send my account link and how to make my account public?

Nothing

01 August 2024 755 1 View

Transfection in HEK293T cells?

Dear All, I am trying to transfect a pCDNA3.1 vector containing my gene of interest. The purpose is to figure out the localization of the protein of interest. I have fused the protein with GFP on...

31 July 2024 9,892 4 View

Are you looking for research collaboration ?

we have few papers ready for submission, and we need one co-author for each article who can pay article fee. Interested authors may text here or contact me on my following email id [email protected]

29 July 2024 6,626 0 View

Why my gel electrophoresis have shadow bands? Please see the attached picture for the gel electrophoresis ?

Sometimes I see the shadow like bands and its not true band. I want to know that what's the reason for it. I am using 2% gel for running genotyping samples I have uploaded the gel picture in both...

19 July 2024 148 6 View

Provide a questionnaire for positive role of politics in nursing ?

I want to write article in a topic of positive role of politics in nursing, and I'm confused how can we add add questionnaire and what will be the questionnaires.

18 July 2024 10,021 3 View

How Can I Resolve a Persistent Unwanted NMR Peak at 1.25 ppm?

Hello everyone, I am facing a consistent issue in my NMR spectra with an unwanted peak appearing at 1.25 ppm. This peak seems to vary with the amount of sample: it becomes more pronounced with...

15 July 2024 9,065 4 View

Can we calculate the CO2 adsorption capacity(mmol/g) of a solid adsorbent (MOF) using CO2_TPD analysis?

what is the relationship b/w TCD signal(a.u) and CO2 desorbed (mmol/g) ? can we plot CO2 desorbed(mmol/g) Vs Time(min) from TPD data?

15 July 2024 3,248 1 View

How to wash capsule filters (Membrane: polyethersulfone; pore size0.2u/0.45u) after filtration. can I wash by NaOH? if yes, what will be the molarity?

NA

11 July 2024 8,969 1 View

Issues in coating of cathode material on Al foil, why we are not getting proper coating and results when the cathode was coated on Al-foil..?

We are trying to coat some cathode materials on Al-foil ( ex - LiFePO4 , S@CNT, etc). When we coated the Al foil with the cathode (ex - S@CNT) material , the cycling result was annoying. But the...

09 July 2024 5,123 4 View

Similar questions and discussions
Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

What is meant by baseline of FTIR data?

I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...

03 August 2024 6,070 3 View

How to calculate the molar proportions of the oxides from the XRF analyses?

How to calculate the molar proportions of the oxides from the XRF analyses?

02 August 2024 2,565 2 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

Entropy measure and QSPR modeling in Graph Theor. How to construct the table for lengthy equation?

The entropy measured of molecular graphs plays a crucial rule. The network structures in some cases are very lengthy calculations to handle. Some author avoid to construct table where as most...

30 July 2024 3,126 0 View

There is possible way to calculate experimental DOS from the UPS spectrum of the material. How to calculate the DOS from UPS?

Here, I have attached the UPS graph. I'm trying to calculate the DOS/DOVS from the UPS.

29 July 2024 4,971 1 View

Critique Calculaltion in Topological Indices and QSPR Modeling?

The first step is to analyze a 2D molecular graph and implement partitioning techniques to calculate the topological indices. Secondly impose statically tools to generate QSPR model, may or may...

24 July 2024 9,644 1 View

How to do calculation of Louvain methods calculation for excel sheet and and is there any software available?

The Louvain method – named after the University of Louvain where Blondel et al. developed the algorithm – finds communities by optimizing modularity locally for every node’s neighborhood, then...

23 July 2024 6,659 0 View

Is there a name for this type of function?

Let n∈ℕ, where the function f:A⊆ℝ𝑛→ℝ, 𝐴 is Borel, and (A,d) is a completely seperable space. What is the name of the functions where the graph of f in any (n+1)-dimensional box of A×ℝ is...

17 July 2024 258 1 View

Why is linearity somewhat lost when plotting the Stern-Volmer (SV) graph?

When preparing a graph of fluorophore intensity vs. analyte concentration, the linearity shows an R² of 0.999. However, when plotting the same data as Fo/F vs. analyte concentration, the linearity...

13 July 2024 7,131 0 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close