Hello
Could anyone kindly tell me how to obtain a temperature distribution, SAR pattern and destructive volume (coagulation shape) at certain temperature using HFSS to validate the efficacy of the design thermally. I tried to simulate the antenna using HFSS but when I tried to obtain for example SAR pattern nothing appeared on the results plot
Do I need another simulation program to get these results? I have read most of the articles about this simulations but I am really confused about I'm doing wrong on how to get these results right!
any suggestions?
It will be Really appreciated!
Regards
Eman
Hi,
You can't use HFSS alone to see the temperature distribution. You have to use Ansys and simulate the model in HFSS and then import into thermal analysis part to see the temprature.
Another solution is using CST MultiPhysics.
Thank you for your reply!
IS CST multiphysics is compatible with the model built using HFSS ?
Regards
Yes. You can import and export between two softwares. Let me know if you have any obstacle with CST Multiphysics
Thank you for your reply!
I have download the ANASYS (student version) using their website as you recommended. I don't know yet if it would work and provide all the results I want as it might be a demo version... I have never used CST multi physics before that's why i chose ANASYS to be a little bit familiar with the setup and steps needed to run such simulations.
Really appreciated your help!
Regards!
- Badges
- Science topic