How to measure flowrate of a fluid using Near Infrared?

More Arjun Sankar S's questions See All

Design of equipment used for membrane distillation?

Has anyone done any work about membrane distillation? If yes please tell me about the membrane that you used and the design of the equipment and it's measurements. Please tell us the factors that...

01 February 2020 7,089 3 View

Silver Copper Ionization Disinfection or UV?

Which among these would be effective water disinfection method? What are the possible disadvantages of UV water disinfection? Can the technology of Cu-Ag disinfection come up in future? What are...

31 December 2019 9,364 4 View

Internet of Things and Chemical Engineering?

I'm an 6th semester undergraduate in Chemical Engineering. I have an inclination towards electronics and computer science and I have always been fascinated about the same. I love chemical...

03 April 2019 8,721 2 View

Using OBD technique i am trying to measure laser induced shockwaves velocity i found that at start velocity increases and then decay?

i am unable to interpret why its increases in start as shown in figure

11 August 2024 2,179 1 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

Strugglling with m6A dot blot any suugesstion ?

I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...

10 August 2024 8,539 5 View

Hello researchers Is this a random laser or just fluorescence?

I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.

09 August 2024 9,894 2 View

Hello all, Looking for international reviewer to review Ph.D thesis in wireless sensor network.Can anybody help?

My name is Apurva Saoji. I am a Ph.D scholar in Computer engineering in India. I am looking for international expert in reviewing my PhD thesis, "Competitive Optimization Techniques to Minimize...

07 August 2024 4,600 2 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

How to determine positive-stained cells in FACS? Use isotype or unstained control?

To compare positive and negative cell populations in flow cytometry, should I compare unstained cells with antibody stained cells? Or with the isotype control? Most papers show comparison with...

06 August 2024 6,728 6 View

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

How can I improve the quality of lamb milk replacer for machine feeding?

Hello everyone, I am researching ways to enhance the quality of lamb milk replacer for machine feeding. I would appreciate any insights or recommendations on the following: Manual vs. Machine...

06 August 2024 6,227 2 View

Why do we equate male and female arousal?

Women, on the other hand, can become physically aroused (increased blood flow in the reproductive organs) without becoming psychologically aroused even in the slightest. (Robert Weiss)

05 August 2024 9,537 2 View

Md. Washim Akram

https://www.sciencedirect.com/search?qs=measure%20flowrate%20of%20a%20fluid%20using%20Near%20Infrared&show=25&sortBy=relevance

Santosh Kumar Singh

You can uae this article "Flow rates for milk and cream in pipelines".

Nazaruddin Sinaga

Dear researchers,

Have a nice weekend with your family....