I am implementing a microgid, and I need to connect a PV array along with a wind turbine, but since I am new on power systems, I am making a mistake in the model: PV array requires discrete powergui, Wind turbine requires phasor powergui, and I cannot have both powerguis in the same model. How is it possible to solve this problem?
I need a simple/easy answer since I am just a beginner in this area
Thanks a lot
Dear Researcher
please check this attachments if it is helpful for you.
Regards
http://in.mathworks.com/help/physmod/sps/powersys/ref/powergui.html;jsessionid=2c30c1973489819416fc45787ad6
Dear Mohan, Thank you so much for this answer, but the problem is that I have the wind turbine and PV array connected to the same power grid, so they are sharing the same model.
I have read somewhere that we can use simparse with some synch. r/g but the answer isn't complete, and I have no idea how to solve this problem.
However, can we have PV model that works with Phasors powergui?
Dear Khadija Tazi as per your problem i will suggest you to have a different software that will be suited best to you that is HOMER(Hybrid optimization model for energy resources ) . Be careful to data of wind & solar power plant .
it will be an easy & best tool for you according to your problem
Multiple powergui blocks can be used. However, the step size must be wisely chosen in different subsystems. The auto mode can take care the minimum sampling time of solver. Likewise, a proper identification of plant with higher sampling rate may be beneficial.
- Badges
- Science topic
- Similar topics
- Chemistry
- Biochemistry
- Biochemical Techniques
- Blotting Techniques
- Immunoblotting
- Dyes