From the paper I know the tensile strength (2087 MPa), Elastic Modulus (152 GPa) and ultimate tensile strain (1.59%). But for the FE modeling, I need the orthotropic material properties-Ex, Ey, Ez, PRxy, PRxz, PRyz, Gxy, Gyz and Gyz. Is there any way to get the approximate value of these parameters?
Thank you for your answer in advance.
Dear Milan Shrestha
Try the following articles:
Conference Paper DETERMINATION OF ORTHOTROPIC PROPERTIES OF CARBON FIBER REIN...
https://community.altair.com/community?id=community_question&sys_id=a1a60c7a1b2bd0908017dc61ec4bcb97
I think that your data are not sufficient. Probably, the elastic modulus refer to an average along-the-fiber measure, but it is not enough to determine useful indications for characterizing the 9 elastic parameters needded for an orthotropic constitutive symmetry.
Data is insufficient, if you have matrix and reinforcement material properties then by using Ansys Design Modeler you can get independent elastic properties of orthotropic material in an easy way.
- Badges
- Science topic