In my tests with a sliding mode triboelectric nanogenerator, I have observed maximum power output at three different resistance values. How should I determine which resistance provides the peak power? E.g max, powr at 1 Ω, or at 1 kΩ or at 1 MΩ ohm
I have made a PVDF film and now I am trying to see the film's performance. I have made contacts on the film with the help of silver paste and attached copper strips as electrodes. But, I am not...
24 June 2024 8,671 0 View
I am working on a TENG project and I would like to know some basic detail. What is the major difference between an open and short circuit operation of a TENG. What is the permittivity of a metal...
20 February 2024 7,873 2 View
Hi, I am working on the fabrication of thermoelectric nanogenerators (TENG). I am wondering how device construction of TENGs will influence the power factor and open-circuit voltage? What is the...
30 November 2023 1,466 3 View
I did a piezoelectric test with a digital oscilloscope and when I hit it with my hand only once I saw it rise and fall several times instead of just once. Immediately after the impact was stopped,...
04 October 2023 8,501 1 View
Nanogenerator
14 December 2022 3,113 2 View
Hello, I am currently doing a Triboelectric nanogenerator simulation in Comsol 5.6 version. I am using electromechanics physics. It comes with electrostatics, solid mechanics and moving mesh. I...
08 April 2022 5,173 0 View
As we know, the triboelectric devices and piezoelectric devices are broadly used in energy harvesting and sensing. What're the each advantages of them for energy harvesting and sensing? Thanks a...
30 November 2021 3,436 3 View
how to reduce the noise while testing the output signal on electrometer of textile based triboelectric nanogenerator? I am getting a noise of 10 V without imparting any frictional force on the...
22 October 2021 6,471 0 View
I am trying to simulate TENG-SC for a project. It would be great if you could suggest on ways to do it.
10 September 2021 615 2 View
I want to coat the Al electrode layer (of about 50nm) on PVDF thin film (having thickness 150um) for nanogenerator application. What should be the process parameters for that?
06 May 2021 7,808 5 View