I want to extract plasmids from bifidobacterium. I have tried to ground the cells in liquid nitrogen, but still failed. Could anybody tell me another method? Thank you very much.
Hello, see this article.
http://onlinelibrary.wiley.com/doi/10.1046/j.1472-765X.1997.00059.x/abstract
The articles from Mitsuoka T. are so good in general.
Best regards,
L.
Hello, I am currently having problems with RNA extraction. I am using mouse liver (C57BL6J), and I have extracted RNA from mouse liver before. Before this experiment, my final RNA pellets were...
11 August 2024 7,082 3 View
I'm cloning a fragment of 3200 nts into plasmid. The cloning was successful, however, 02 amino acids were mutated. Now I want to fix these 02 aa by site-directed mutagenesis technique using...
08 August 2024 4,645 2 View
I've been performing RNA extraction on cotton petiole tissue for a few months now using the method described in the following paper, a derivative of the typical hot borate method...
08 August 2024 9,882 2 View
Hi, I know that low molecular weight (MW) molecules generally tend to have higher mobility, while high molecular weight molecules tend to have lower mobility. However, in my experimental...
06 August 2024 1,495 2 View
After immunohistochemistry of previously fixed in PFA and EtOH and then frozen 20 μm sections of zebrafish brain, DAPI staining is very weak (right) compared to the same sections stained without...
05 August 2024 9,637 2 View
Hi all, I need to introduce an ARS (autonomously replicating sequence) in my plasmid but I'm not sure which position would be the best. Does anyone have any suggestion? A picture of the plasmid...
05 August 2024 1,573 4 View
I want to introduce a point mutation (change in one nucleotide) into my gene of interest (DNA binding domain) I have designed primers as recommended on the Data sheet of the kit : -Both primers...
05 August 2024 9,059 3 View
I am performing ligation of the plasmid and a target gene. The steps I have taken are: 1. Double digestion of the plasmid and target gene 2. Ligation of the plasmid with the target gene 3....
05 August 2024 2,570 3 View
I am having an issue with my gel image where my PCR product is not appearing very bright on the gel. When I perform gel extraction, the A260/280 purity value is very low. I used the Qiagen gel...
05 August 2024 9,798 3 View
kindly reply me. Thanking you in advance.
05 August 2024 7,727 4 View