Can we classify HV and LV lines based on line length?

I have dataset which shows the length of power lines. I need to classify the lines based on the line length. Is there a rule to classify the High voltage (HV) and low voltage (LV) lines based on...

03 March 2021 4,116 4 View

Does the circuit modeling for planar monopole antennas using Foster canonical forms give good approximation?

Hi researchers, I am searching for some accurate way to do the circuit modeling of planar CPW-fed monopole antennas. I have gone through the literature where mostly circuit modeling is done using...

28 February 2021 7,016 1 View

How can we theoretically calculate Elemental analysis(percentage) of atoms in covalent organic framework?

For example in one research article the Elemental analysis values of COF-TpPa-1 ( Triformylphloroglucinol (Tp) (63 mg, 0.3 mmol), Paraphenylenediamine (Pa-1) (48 mg, 0.45 mmol) are as follows...

24 February 2021 1,265 6 View

Is there any teachers based in UK who would like to take part in my study?

24 February 2021 4,833 3 View

SSR primers are species specific or we can use it for any plant species ?

Hi, any one please guide me; SSR primers are species specific or trait specific. i have few primer which was reported in articles for wheat yield can i use these similar primer for lentil yield...

20 February 2021 315 4 View

In CDA analysis we have three stages, viz., description , interpretation, and reproduction. Why have all CDA studies neglected the third stage?

In CDA analysis we have three stages, viz., description , interpretation, and reproduction. Why have all CDA studies neglected the third stage?

18 February 2021 6,483 3 View

Can I use a categorical covariate in a Generalized Linear Model in SPSS v.26?

Hello everyone, hope you are well. I am planning to use a Generalized Linear Model in SPSS. I would like to add gender to the model as a covariate, however from what I have read, only continuous...

14 February 2021 8,937 4 View

How to plot Random Forest model as raster prediction map in RStudio?

Output_raster

27 January 2021 7,974 3 View

What solvent is suitable for ferric oxide nanoparticles?

Please help me suggest the appropriate solvent for the ferric oxide nanoparticles for the possibility of exploring their use in cancer treatment .. Your suggestions are very important to me.

11 January 2021 5,321 4 View

Do you have datasets for Covid-19 Chest X-ray and CT Lung labeled dataset?

I am working on COVID-19 detection and analysis challenge. Please, share me the labeled dataset. My relevant articles are : 1. COVID-19 Detection in Chest X-Ray Images using a New Channel Boosted...

02 January 2021 3,609 9 View

Multi effect distillation modeling in EES?

Dear colleagues If anyone has a model of multi-effect distillation in EES or MATLAB software, please send it to me.

24 February 2021 7,282 1 View

Why does TRNSYS keep sending zero radiation to my ees CPVT collector model?

Hi, I entered the equations for a CPVT collector in ees and linked the model to TRNSYS to use in my simulations, the inputs (ambient temperature, atmospheric pressure and wind speed) are given to...

17 September 2020 9,374 1 View

About Refprop and MATLAB link?

Dear Colleagues I hope you are doing well. I want to link MATLAB and ref prop software. For the pure mixture, link works well. But when I want to calculate the mixture of ammonia and water the...

09 June 2020 4,574 14 View

A code in EES is required for simulating ejector cycle?

How value of P_m will be calculated by iteration? All values on LHS of equation 13 and 14 are known P_m, h_mix, u_mix and v_mix are unknown quantities See equation 13,14,15,16 w is also...

01 May 2020 5,313 1 View

How can i write exergy analysis codes in EES for cascade refrigeration system?

please sent to me some codes of exergy analysis.(with article)

17 October 2019 6,382 3 View

How can i write exergy analysis codes in EES for cascade refrigeration system?

please sent to me some codes of exergy analysis.(with article)

09 October 2019 5,796 3 View

Does anyone know how to link EES software with Matlab?

Hi all, I am trying to use my code in EES software and link it with Matlab to do multi-objective optimization without rewriting the code again. Does anyone know any methods or approaches? Thank you,

09 October 2019 3,326 2 View

Does anyone know how to link EES software with Matlab?

Hi all, I am trying to use my code in EES software and link it with Matlab to do multi-objective optimization without rewriting the code again. Does anyone know any methods or approaches? Thank you,

08 October 2019 8,569 3 View

MED (multi-effect desalination) simualtion code?

Dear scholars, I'm working on a project that uses some waste heat to provide the motive steam for multi-effect desalination with the thermal compressor. Pressure, Temperature, and flow rate of...

20 September 2019 3,268 2 View

Hello,friends.I want to model ejector in EES,my fluid is NH3H2O.What I can calculation cp and cv for modeling?

For modeling ejector we need to have cv and sound speed.when our fluid is NH3H2O.How we can reach it.thanks

24 August 2019 2,695 2 View