What is acceptable level of coefficient of variation (COV) for a newly developed testing method?

I have developed a method to determine tensile strength of a composite. What level of COV is required for it to be acceptable? Kindly mention sources too.

05 June 2019 1,614 1 View

How to conduct single element test for a developed subroutine?

I am developing a material model for finite element code. I conduct single element tests in Abaqus and LS-dyna but I was wondering if there is a set procedure for them. If not, kindly share how...

05 June 2019 4,805 4 View

I have written a VUMAT for composites. For impact problem, I am getting error of nodes penetrating surfaces. Kindly help me?

I have used general contact with internal surfaces included in definition. Also VUMAT is tested for single element model and results are as expected.

06 July 2018 4,972 8 View

Simulation of ballistic events on composites using ABAQUS

01 January 1970 4,869 5 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View

Ideas for Phd's Thesis on pricing (Marketing)?

Hi everyone, I'm studying Marketing and I would like to write my PhD thesis on the topic of pricing. Any specific ideas?

02 March 2021 9,706 5 View

How to write a scientific report?

We are analysing scientific reports at University in great detail, so I wanted to find a scientific report about how to write a scientific report. Including detail such as what information to put...

02 March 2021 7,602 4 View

Could any one guide me, to write research proposal for grant? ?

We have one plant, the local people using this for controlling blood sugar, the toxicity and antidiabetic activity of the plant is not reported yet, please guide from whag should be the process ?...

02 March 2021 2,300 1 View

Energy minimization in LAMMPS using NVT ?

How do I do energy minimization in lammps with NVT ensemble ? I am using the following command and it does not seem to work. It stops at extremely high energy and gives me the error zero search...

01 March 2021 2,294 3 View

No title

01 March 2021 3,905 5 View

How to Balance Bench work with Reading and Writing?

I am a second-year grad student. I am finding it difficult finding time to read literature and write (things like qualifying exam, thesis, grants). I find myself so busy with bench work that I...

01 March 2021 3,325 4 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

Which software is better to write systematic review paper?

We have seen some authors use some software to write review paper. As obvious, the study of all published papers concerning our studying field is not possible and these software can help us to...

27 February 2021 6,296 1 View

How can we raise the figure when we writing a paper with Latex ?

Hi, everyone. I'm a starter to write a paper by Latex. But I have some difficulty using it. I'm writing the paper with 2 columns. And, there is one figure that occupies the 2 both-sides. I want to...

26 February 2021 3,738 3 View