How to detect small wire that is close to the sensor and give an output?

Hello all, Looking for international reviewer to review Ph.D thesis in wireless sensor network.Can anybody help?

My name is Apurva Saoji. I am a Ph.D scholar in Computer engineering in India. I am looking for international expert in reviewing my PhD thesis, "Competitive Optimization Techniques to Minimize...

07 August 2024 4,600 2 View

Any direct measurement to measure the bacteria or micro organism using IOT or any indirect measurement?

need of sensor details or sensor development for this question.

28 July 2024 4,539 3 View

Hellow every one i have a question, please help me. How ESP car working?

I try to understand the ESP mechanism working. What kind of sensors it has, Is it necessary to modify or boost its mechanical ?

15 July 2024 4,772 1 View

What do you think are the key challenges that need to be addressed in the future development and application of these three devices?

Continuous glucose monitors (CGMs) help patients and doctors make more timely management decisions by monitoring blood glucose levels in real time. An insulin pump provides continuous insulin...

07 July 2024 7,742 0 View

How can I find the absolute maximum value of the Lamb-Oseen vortex with a no-slip condition?

R(t) = the propagation function of the vortex, where R=sqrt(4vt + R0^2) R0 = initial radius. w0 = initial angular velocity. Rf = the radius of the boundary confining the fluid. The Lamb-Oseen...

07 July 2024 3,680 0 View

How to confirm if quantum confinement effect was occurred?

I'm making quantum well with 2 different bandgap materials, but I'm not sure quantum confinement effect was occurred because the well width is ~ 60 nm. How can I make sure that effect? Is there...

02 July 2024 8,426 1 View

Does the quantum confined effect affect the peak position of PL intensity?

The lower PL intensity for ultrathin MOF than that of bulk MOF also indicated a quantum confinement effect due to the ultrathin morphology of Cu-UMOF.

27 June 2024 4,855 0 View

How to reduce the material coming out of the torque rheometer?

A physical mix was in vitro evaluated on a torque rheometer. The composition was predominantly recycled polypropylene (PP), yet the melt flow index (MFI) was found to be excessively high....

25 June 2024 10,154 0 View

Why aren't primary MHD generators with tokamak/stellarator configurations studied/researched?

Magnetohydrodynamic generators are normally used as eihter an attachment to recycle wasted heat and flow of other generators, or used to absorb the energy from rocket thrusters. However, I'm...

24 June 2024 3,949 1 View

How to achieve optimal bonding strength at the wire-bonding process?

Hello everyone, without going too much into details, my thesis is about improving the bonding strength at the wire bonding process. I should focus on laser pretreatment of the substrate. Has...

17 June 2024 366 1 View

Nikolay Pavlov

Is it always steel or some metal at least?

Garrett Riedesel

Nikolay Pavlov The wires will be shielded if that is what you are meaning.

Garrett Riedesel You mean electric or magnetic filed cannot be used - correct?

Nikolay Pavlov We can not use those fields were thinking something along the lines of an LED emitter and receiver that covers an area.

Perhaps you can use shadow sensor. This way, it is not difficult to sense even 50 um diameter droplets. You just AC couple low noise amplifier to illuminated photodiode.