How to calculate wear rate at nano scale level?

01 January 2016 1 10K Report

tribology

I do not know about wear rate. I have done some experiments to estimate scratch hardness (wear resistance). Go to below link. It might be helpful.

http://www.sciencedirect.com/science/article/pii/S0032386116301227

Badges
Science topic

Similar topics
Chemistry
Nanotechnology
Nano

What is Nano technology with coronavirus helpe the human..and is it nano mterals removal of covid19?

I anwar by adsorption or reaction ..but it is either more method...

02 March 2021 4,811 2 View

How to compare different concentrations of nanoparticles for characterization from ICP-MS?

I took measurements of different concentrations of 15 nm and 5 nm Au nano particle solutions. I'm trying to determine which concentration I measured gives the best reading overall. I also...

02 March 2021 7,626 1 View

Can polymer concentrations be calculated based on the number average molecular weight?

Hello, I spin-cast two different polymers onto wafers and measure their height as a function of initial concentration. For polymer A, I have the weight-average molecular weight (Mw) as well as...

28 February 2021 7,882 2 View

LEDs on Vis Light photo degradation of MB water sol via N doped TiO2 in a mini flume?

Good day to all, I have no experience with light emitting diodes. I am building a glass mini flume to demonstrate the photo degradation of Methylene Blue in water running over self cleaning...

26 February 2021 4,026 5 View

Zno nano particles colour changed from white to grey in process of calcination any suggestions?

In the formation of Zno nano particles process, after drying at 120 degree C, my zno nano particles are completely white but when i calcine it for 450 degree C it converts into grey colour. i...

26 February 2021 2,435 4 View

Alternative to mediation analysis?

I am currently working on my dissertation and want to explore the role of competence as a mediator between the effect of colour of clothes on voting intention (focus on Western countries)....

21 February 2021 8,609 1 View

How to resolve Gaussian error termination " Error termination via Lnk1e in F:\G16W\l103.exe" for TS(QST3)?

When I run the job for TS(QST3) in gaseous phase, it was completed without any error. But when I add water in CPCM model it terminated with an error: Inconsistency: ModMin= 2 Eigenvalue=...

21 February 2021 3,198 2 View

Using the Pfaffl method: Is it possible that the ratio of the calibrator does not equal 1?

Hi all, I have a question regarding calculations using the Pfaffl method. I have 3 groups per experiment: 1 control group (calibrator) and 2 treatment groups with 6 to 7 biological repeats per...

19 February 2021 8,351 2 View

Has anyone done Archard Wear Simulation of GFRP Composite Plate in ANSYS with ACT extension or UDF?

I'm looking to do a sliding wear (plate-on-plate) simulation of GFRP composite plates with Archard Wear Model. Any hints or example steps are appreciated.

17 February 2021 1,447 2 View

QPCR tubes for Roche Lightcycler Nano?

We own a small cPCR thermal cycler from Roche, Lightcycler Nano, which is convenient for backup quick runs. Recently, Roche has discontinued the plastics for it and they offer no alternative from...

17 February 2021 8,694 5 View