What is are the different classifications of a tool changer?

I have roamed the internet trying to see the different types of tool changers available but I found no definitive answers, could you kindly help me?

02 February 2021 5,036 1 View

How can the moment tensor inversion results can present good waveform fit (synthetic and observed waveform) from generalized Cut and Paste scheme?

Depending upon the distance of the seismic station from the epicentre, the quality of waveform data and the improvisation of the synthetic waveform on it is often a question. If the Pnl waveform...

31 December 2020 6,602 2 View

How to calculate covariance of Expectation Maximization Clustering?

I am working with MatLab R2017a, I have to implement EM clustering. But I am stuck with initialization of covariance in it. I have to calculate covariance using the dataset which is comprised of...

25 December 2020 4,620 3 View

MatLab code for Expected Maximization clustering of n-Dimensional data?

I need matlab code for expected maximization clustering of n-Dimensional data. I have searched and found code related to 1-D and 2-D. Can someone refer the code for n-D .

22 December 2020 5,110 3 View

Where can I find papers related to microstructure of inconel alloy 800?

I need to define the microstructure of inconel 800, but I cannot find any literature related to it. Literature is about incoloy 800 mostly which is a bit different. Can anyone tell me if there...

07 December 2020 3,137 3 View

Which software application is best for Anova analysis?

I want to perform "ANOVA" analysis of three different vegetation indices. anyone know how can i perform and which application /software are suitable for this. Thank you in advance.

16 November 2020 2,599 4 View

How can I specify the parameters for nano creep?

Which parameters should I employ for nano creep testing of Titanium and Inconel alloys? Should I load it with a constant load rate or strain rate? What should be the maximum load? What should be...

29 October 2020 5,727 4 View

How to find the elastic work using nanoindentation load depth curves?

I am using work of indentation approach to find out the values of hardness of Ti and Inconel alloys using nanoindentation load-depth curves. I can find the formula for total work. Whereas for...

13 October 2020 2,778 5 View

How to measure the volume of hydrogel?

08 October 2020 2,745 9 View

Why nickel oxide nanoparticles do not have single band gap?

band gap for nickel oxide nanoparticles is 3.85 to 3.45 eV

23 September 2020 260 4 View

How to analyze a particular region of my simulation box in GROMACS?

Hi, I am using GROMACS 5.1.4 to simulate water in contact with a surface. I am only interested to calculate some properties of water near the surface. Let's say at a distance of x nm from the...

03 March 2021 9,989 2 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

How to prevent ANFIS Model from negative prediction values in MATLAB?

I have input and output data set for "ANFIS modeling in MATLAB", and I am getting some negative predicted values of output in testing. However, the predicted values of output in training are...

28 February 2021 3,459 3 View

How does an AC-DC power supply Flyback Converter Based USB Charger Model using Matlab/Simulink looks like?

I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...

25 February 2021 5,435 2 View

Please. Could you help be in implementing Fractal Discrete Cosine Transform algorithm in Matlab?

I do need the Matlab code of Fractal Discrete Cosine Transform (FDCT). Can anyone who has already implement this code, help me with the implementation of this transform?

24 February 2021 5,602 2 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

Multi effect distillation modeling in EES?

Dear colleagues If anyone has a model of multi-effect distillation in EES or MATLAB software, please send it to me.

24 February 2021 7,282 1 View

What program can I use to caclulate dipole moment efficiently and without the need of excessive computation?

Hi, I am a third year chemistry undergrad doing my group project in which I need to predict the HPLC retention time of 20 aromatic molecules. to do this we require the chemical properties of these...

24 February 2021 1,384 3 View

Does anyone ever solved this following Matlab error : "Error using imaqdevice/start (line 95) pointgrey: Failed to stop the camera acquisition." ?

I use Matlab 2014b to capture some images with a PointGrey camera connected with USB3 port. I initialize the camera in a function which basically execute these followed lines : vid =...

22 February 2021 6,386 1 View