How should I measure apparent density when powder flow ability is low?
You may find your answer on ASTM B212 or ASTM B703.
If your powder is a "Non-Free-Flowing powder", you can refer to ASTM B417-13 to measure the apparent density using the Carney Funnel
Thank you Behzad and Imad
I need to have Current for a constant current mode on a DC power supply. And I need to understand how to assess the coated surface too.
01 February 2017 3,321 0 View
I run mechanochemical reactions that involves the use of a large amount of catalyst (1:1 molar ratio to the reactant). When I try to understand the effect of amount of catalyst on the reaction, I...
23 July 2024 9,938 1 View
I am searching for HPLC method to estimate Mirtazapine but i want to avoid HPLC-buffers as a mobile phase component. So, I am looking for alternative HPLC-solvent (acetonitrile, methanol etc.)...
14 July 2024 1,493 3 View
I am working on powder metallurgy, and during the compaction process, the powder does not pelletize and remains in its powder form. To address this issue, I am considering using binders to improve...
13 July 2024 9,003 2 View
I am trying to load curcumin emulsion in 4% chitosan gel but i don not know how many mg powder is needed ?
10 July 2024 2,462 1 View
I have to compare the FTIR of the two samples, one is in powder form and other one is the powder dispersed in IPA or water. Both are same material, so how the bond will change
09 July 2024 8,011 2 View
Is any specific sample preparation required to perform VSM measurement of NdFeB alloy powder to get a square-shaped M-H loop? Or is it mandatory to make magnetically aligned and sintered pellets...
09 July 2024 1,969 0 View
In this model clearly understanding how to active one layer to another layer and how to add powder material properties step by step.
08 July 2024 6,147 0 View
Good evening, I would like to evaluate the heavy metal content in bird feathers. Can I keep my samples in powder form ? and can I use other tubes than Teflon for digestion?
04 July 2024 158 4 View
I am using fibroblast growth factor, purchased in powder form. What suitable substance should be added to get it in a liquid form? Thanks
03 July 2024 9,866 2 View
I synthesise intermetallic compounds through nickel and aluminium powders. But the pure powder after synthesis is difficult to obtain. Especially the presence of aluminium oxide very seriously...
01 July 2024 4,030 3 View