How can I view the absorption peaks of highly diluted suspension liquids?

I had synthesized MoS2 nanosheets by the help of liquid phase exfoliation using probe sonication. The solvent used was a 50/50(vol%) of IPA/DI water mixture. Pre-processing of the sample was...

30 January 2019 5,421 5 View

Biasing circuit for varactor/pin diode in reconfigurable antenna?

I need to know abt biasing ckt for varactor and PIN diodes to be used in reconfigurable microstrip filter. I have seen ckt given in datasheet. It seems it is having more inductor and capacitors...

06 December 2018 5,543 5 View

Natural frequency of a cantilever in underwater environment obtained is a comlex number. How can i obtained the numeric value of natural frequency?

In comsol i have created underwater environment using pressure acoustic is it the right way to do so?

07 April 2018 7,713 3 View

How to simulate combustion in diesel engine?

29 August 2017 9,883 5 View

Can anyone let me know the value of Hansen solubility parameter for poly-L-lysine or L-Lysine?

04 May 2017 4,271 2 View

How to apply Load ratio (R ) zero for the cyclic loading in the Abaqus?

I am trying to apply cyclic loading on the cell model of cast iron. I need to apply load ratio zero. I have tried to do the same using Amplitude tool in the Load module, using periodic amplitude...

02 February 2017 3,926 3 View

No title

05 August 2016 8,011 2 View

Is there any significant difference in numerical simulation results between 2D & 3D geometry for steady state heat transfer problem?

I want to evaluate performance of heat spreading capacity of copper heat spreader. In which silicone chip (Source) is connected with Copper plate (Sink). I had simulate problem with steady state...

29 April 2016 9,257 3 View

How can I remove NaCl salt from Organic compound which is only soluble in DMSO?

Its Pteridine type compounds.

19 January 2016 7,297 13 View

How do I plot empirical probability density function for an array of complex numbers in MATLAB?

30 March 2015 5,837 3 View

What is the most Operating System (OS) which can be INSTALL on Tiny hard devices like Raspberry Pi (RPi) hardware ?

I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...

03 March 2021 1,931 5 View

What is your perception on using visual analysis or quantitative approaches to evaluate data from single-case research designs (n of 1 trials)?

Results of single-case research designs (i.e., n-of-1 trials) are often evaluated by visually inspecting the time-series graph and computing quantitative indices. A question our research team is...

03 March 2021 687 1 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

Which is suitable for use with Python? MySQL or SQL Server?

Which is suitable for use with Python? MySQL or SQL Server? What is your suggestion?

01 March 2021 3,422 3 View

How to improve and implement WBAN MAC and Radio modules under Castalia 3.2 ?

Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...

28 February 2021 400 1 View

How to plot the probability paper of Gumbel distribution using R programing?

In R-studio, there are many commands of Gumbel package. Arguments are also different. I`m asking about the alpha parameter of the Copula which must be greater than 1. If this is the one used to...

25 February 2021 5,229 3 View

What are the patterns of human behavior that lead to COVID-19 infections?

Does data from contact tracing help in establishing patterns of behavior and social interactions that lead to infections? There are cases here in the Philippines where patients have no travel...

25 February 2021 9,002 13 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View