During network reconfiguration process the status of most of the switches will change, now suppose a switch is in ON position initially and after reconfiguration it is OFF and now the load connected to it will be supplied by some different line through another switch,so during this change for a small period of time the load won't get any power.And this small duration power cut is not good for many industries and is not acceptable in many countries for domestic loads also.So I want to know how electric utilities manage this problem?
1. Through ON and OFF line system
2. Through Priority based power line system
Ishan,
To give you a general reply: by automation.
Substation automation is a big area of technology - you may be aware ! There are dedicated industries that have made millions in this area.
-Sanjay
Good coordination and correct adjustment of protective relays and automatics.
If reconfiguration is driven by power flow optimization, one should switch ON the breaker through which load is expected to be supplied after reconfiguration. Only after that one should switch OFF the breaker through which load was supplied before reconfiguration.
The same is valid for any planned reconfiguration.
If reconfiguration is driven by contigency, you will have supply interruption any way.
- Badges
- Science topic
- Similar topics
- Engineering
- Electrical Engineering