I download CDMA2000 Simulink model and opened the Simulink model. Then initialized it. Finally, I ran it but it gave me two errors as follows:
1-
For S-function 'sdspupfir2', the number of defined parameters, 27, does not match the number of parameters on the dialog of 'cdma2k_phlayer/Rx Antenna/Rake Receiver/Rake Finger/Channel Estimation/Low Pass Filter', 4. These two values must be identical.
2- Error in S-function 'cdma2k_phlayer/Tx Antenna/Spreading Non-TD Mode/expand PN Sequence': S-Function 'expandPNSeq' does not exist
I do appreciate it if anyone help me to solve this problem.
I have attached the zip file of CDMA2000 Simulink model below.
Well i am using MATLAB R2013a. I have run the simulink simulation. it is running fine. i am not getting any problems.
Dear Habib
Thank you for your comment. May I ask you how do you run this Simulink model. Probably, I run it in a wrong way because I am not so sure about it.
Thank you in advance
Dear Habib
I used the same Matlab version but I have got errors mentioned above. Did you use the package which I attached?
I am also using the same version but it is not given any error.
Dear Sur
Thank you for your reply. May I ask you that how do you run this Simulink model to check whether I am doing right or not?
I have just open the cdma2000 file from demos and then run it. After that I have save it to some other location and again simulated. It is working properly. I have just attached it. Please check it.
- Badges
- Science topic