How could weighting potential for virtual frisch grid be simulated for Plane Semiconductor Detector?

08 August 2016 0 2K Report

Can you give some ideas how could weighting potential for virtual frisch grid be simulated / calculated for Plane Semiconductor Detector?

Badges
Science topic

More Abhinav Kumar's questions See All

I need to make a 4D intensity plot where colour will represent the fourth variable. and X,Y and Z would be axes. It is possible in labview ? How?

need to make a 4D intensity plot where colour will represent the fourth variable. and X,Y and Z would be axes. It is possible in labview ? How?

04 May 2017 2,719 3 View

How could weighting potential for virtual frisch grid be simulated for Plane Semiconductor Detector?

Can you give some ideas how could weighting potential for virtual frisch grid be simulated for Plane Semiconductor Detector?

07 August 2016 9,222 4 View

Smart grid ideas?

How to use and this is economical?

06 August 2024 3,160 2 View

How to clean the CAD detector?

The module of the CAD detector is corona Veo. It has been idle for a long time. And it was not well maintained before idle. I have replaced the gas filters and flushed the system with a 50/50...

01 August 2024 7,805 0 View

¿Are oxygen vacancies in semiconductors capable to change the band gap?

Dear all! Oxygen vacancies do raise negatively the Fermi level by increasing the negative charge in the semiconductor crystal structure. In the case of n-type semiconductors, I wonder if this...

30 July 2024 8,339 2 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

How do you decide an optimal AC amplitude for non-faradaic electrochemical impedance spectroscopy?

I work with planar interdigitated electrodes (IDEs). The finger width and the spacing between the fingers are 5 micron. The surface of the IDEs is coated by a non-conductive polymer layer...

16 July 2024 5,031 1 View

Can someone help with the instrument configuration in Profex using Rietveld Refinement?

I am trying to configure the instrument in Profex but I can't get a chi-squared value below 9.65 for LaB6. This is the configuration of the equipment, which is a Bruker D8 Advance with a Linxeye...

14 July 2024 4,767 1 View

How can novel network architectures, such as software-defined networking (SDN) and network function virtualization (NFV), in Handover?

How can novel network architectures, such as software-defined networking (SDN) and network function virtualization (NFV), contribute to improved handover performance and reduced latency in future...

12 July 2024 6,183 1 View

How to apply virtual site for a polymer?

Dear All, I have a PDB structure for a complex and large polymer. I need to perform MD simulations using the OPLS-AA force field. I obtained the force field parameters from LigParGen and created...

11 July 2024 5,109 0 View

What is the best software for simulation of mode locked diode laser?

Hi Dear All I would like to simulate a mode locked semiconductor laser. Does anyone know what is the best software to do it?

06 July 2024 1,648 4 View

Has India been largest exporter of virtual water in world & virtual water trade affect environment & relationship between virtual & a water footprint?

Has India been the largest exporter of virtual water in the world and virtual water trade affect the local environment and relationship between virtual water and a water footprint?

03 July 2024 4,529 7 View