??
08 September 2016 6,515 0 View
In power factor correction I have seen many paper they use PLL to generate reference signal. but it is also possible to sense input voltage and generate reference signal. is it mandatory to use PLL ?
04 May 2016 2,556 9 View
Can anybody attach simulation of two switch buck-boost PFC converter?
04 May 2016 2,619 0 View
03 April 2016 7,612 0 View
Your toughest technical questions will likely get answered within 48 hours on ResearchGate, the professional network for scientists.
08 September 2015 7,700 0 View
07 August 2015 3,612 1 View
How can we get differentiation of signal in matlab simulink, if signal is part of power electronics converter circuit with switching frequency 30Khz ?
06 July 2015 1,948 2 View
I have an experiment with 28 participants The independent variable is the times 1, 2, 5, and 10 used as the cross hairs during a task These 4 times were tested using 4 different blocks, each...
03 March 2021 9,692 2 View
My study consists simple corrosion inhibitors in salty brine. Right now I just fit my circuit with randles with CPE. Just wondering how the slop can given more info of the experiment. Or any...
01 March 2021 6,474 3 View
Hello, I have simulated a single battery cell using Thevenin equivalent circuit. For a battery pack, I have a large number of cells connected in series and parallel connections. Is there any way...
28 February 2021 2,116 1 View
Hi researchers, I am searching for some accurate way to do the circuit modeling of planar CPW-fed monopole antennas. I have gone through the literature where mostly circuit modeling is done using...
28 February 2021 7,016 1 View
I have a doubt on how to select the inductor and capacitor value when I want to implement MPPT controller. This is because we always take a maximum output voltage and current but in this case, we...
28 February 2021 3,637 2 View
I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...
25 February 2021 5,435 2 View
How to build fouling and erosion simulation model for Aero Engine compressor and turbine rotor in Simulink / Matlab?
22 February 2021 3,697 1 View
Dear Professors, Colleagues and Friends I need to develop a simple Matlab/Simulink model of reverse droop controller for a simple LV MG. How can I get a simple one to use it as a sample? A basic...
22 February 2021 8,647 2 View
Hi, I'm looking for a dataset of a PMSM with an inter turn short circuit fault. Does anyone know a dataset which is available?
21 February 2021 5,663 2 View
[Images are attached at bottom] I am currently working on a buck converter controlled by two different control methods, Reinforcement learning applied to find PID values & a lead-lag...
16 February 2021 5,060 10 View
