How can we can find zigbee's mode on opnet?

More Saeid Mot's questions See All

Can anyone help with broken line in opnet for zigbee?

In many simulation with opnet I saw researcher connect nodes with together with broken lines which shows the connection between nodes (like blue broken lines on attached files). How may I create...

03 April 2014 7,522 1 View

Where can i view "printf" output in opnet?

I use "printf" in my codes but I do not know how to view it's result.

02 March 2014 1,272 6 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

Arena simulation - how do i model the following model in ARENA (see description) (new to ARENA)?

Hello, I'm fairly new to ARENA and I have the following problem: I have two queues in which, in each queue, a different order type arrives (both having an arrival rate of exponential 10). Order...

02 March 2021 2,431 3 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

Why the results when using wall thickness and when using shell conduction are different in ansys fluent?

Actually, I am running cfd simulation for a heat exchanger which has two fluids one hot and other one is cold fluid. there is a solid domain between them, which I removed and instead I have used...

01 March 2021 9,537 2 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

Joint behaviour in Abaqus is not captured well?

I am working on roof joint and trying to simulate the behaviour in Abaqus. I am successful in running the model but the final graph does not follow the experimental curve in the negative direction...

01 March 2021 6,661 3 View

In Molecular Dynamics Simulation, how do I make changes to the force field according to my protein?

Hi In Molecular Dynamics Simulation, how do I make changes to the force field according to my protein? I got this error in the add-ion stage: Fatal error "./ amber99sb-ildn-HHH.ff / force...

01 March 2021 8,747 4 View

Imad Jamil

Normally these are node attributes ...

Saeid Mot

U can see them after simulate

is there any KP to See them?

If you're asking about configuring them, then you can find the Physical Layer Parameters in the local attributes of a Zigbee node.

Else, if you mean the results at the end of the simulation, check the statistics, usually you can find throughput and many other useful statistics ...

Thanks,but i want to know node's situation while simulate it.because i want to write a process for zigbee to model a battery. Zigbee has 3or 4 working modes (send,recive,idle modes and i think one another mode) and energy consumption is different in each mode. I want to find energy consumtion by modeling battery for zigbee.