How can serverless computing enhance scalability and efficiency in advanced cloud architectures?

03 January 2024 0 8K Report

Explore the impact of serverless computing on scalability and efficiency within advanced cloud setups. Assess its potential benefits, challenges, and optimal use cases for achieving high-performance cloud solutions.

Badges
Science topic

Similar topics
Design
Architecture

More S M Mohiuddin Khan Shiam's questions See All

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

RIA. How to measure?

When you use RIA, with a control the unknown sample with antibodies, you bare in mind the binding sites of the antibodies. However you still need to measure labelled antigen (radioactive) and not...

28 February 2021 2,133 3 View

Benefits of the 24 welled plate?

We have always used the 96 welled plate, the 48 welled plate but apparently there is much evidence on the 24 welled plate and above all its benefits.It states it is the same you would use on ELISA...

28 February 2021 1,149 1 View

What information can be had from raman at higher wavenumber?

i have recorded raman spectra of strontium oxide thin film. the spectra were recorded in the range 400 to 4000 cm-1. i have reference to peaks upto 1000cm-1. but i couldn't find literature for...

26 February 2021 2,499 1 View

What are the methods used for CNT..?

Respected Professor's i hope you are doing well and happy. i need some information about carbon Nanotubes. before blending the CNT with the matrix the CNT has been introducing in some treatments....

24 February 2021 5,383 5 View

Langevin Dynamics in shear flow?

Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...

23 February 2021 1,761 1 View

How can I homogenize this data to make a meta-analysis?

Hi, I am doing a review and hopefully meta-analysis for my Master thesis but I have the following problems: - Some studies only give the difference between end trial and baseline data and other...

22 February 2021 1,115 4 View

Research Gate Does it help researches to publicize their scientific work ?

In my opinion, the RG site is useful in solving scientific problems and shows the researcher's ability. Besides, the separation of the H-index from the self-citations and the overall index is an...

22 February 2021 3,894 6 View

Monte Carlo simulation?

Hi, i am conducting a Monte Carlo simulation for my new distribution but the MSE values are increasing while the sample size increase, does any experience this issue before and what should i do...

22 February 2021 3,680 4 View

What is your perception on using visual analysis or quantitative approaches to evaluate data from single-case research designs (n of 1 trials)?

Results of single-case research designs (i.e., n-of-1 trials) are often evaluated by visually inspecting the time-series graph and computing quantitative indices. A question our research team is...

03 March 2021 687 1 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

Is stone a sustainable material? Is it a sustainable approach to use natural stone waste in architecture?

I'm designing a zero-waste restaurant and considering using marble waste to make some tables and a bar countertop. My clients think it's not "sustainable enough" and I would like to have more...

01 March 2021 4,326 7 View

Is there any available free access High Performance Computing (HPC) servers with GROMACS?

I would like to run a Molecular Dynamics (MD) simulation using GROMACS in a high-performance computing server. Is there any freely available one out there? If yes, please do not fail to make...

16 February 2021 2,593 3 View

Which DL architecture is better to work on handwritten data?

I am working in the area of Handwriting recognition for Bangla. As there are many DL architecture, I am confused which one to select.

15 February 2021 4,996 1 View

Are cloud points able to identify tree species?

Hello Dears My goal is to classify dense forest tree species using drone images. Is it possible to classify dense cloud points? If yes, in what way and in what software? Thankful

15 February 2021 3,475 3 View

Can I use the CHARMM GUI input files for Gromacs in HPC?

Good day everyone! I am a Biochemistry undergraduate in the Philippines and to be very honest, we have no background in bioinformatics since we really focused on wet lab techniques + theory. Due...

15 February 2021 3,422 4 View

PV system design. 3d modelling and Analysis?

I have been looking for a good cost-effective tool for 3D modelling a glass-glass solar module system. I was initially considering Skelion as a tool but it does not look very promising, a bit...

13 February 2021 8,126 1 View

Useful architecture for bioinformatics?

Hi Dear researchers In ensemble-based architectural design Which algorithms are more useful for classification? What is the difference between parallel and ensemble architecture? Thanks I am...

08 February 2021 2,727 5 View

Infinite order of Laguerre?

If Lmn(x) is the Laguerre polynomial of order m and degree n Is there a means of computing Lmn(x) for 1) m goes to infinity 2) n goes to infinity

08 February 2021 6,320 4 View