I am assuming this is a gas adsorption experiment. You need a packed column, mass flow controller and valves upstream of the column, a flow meter and a detector down stream. Additionally you need provisions for data logging and controlling flow controllers and temperatures with labview

If you're talking about the liquid phase dynamic adsorption，you can use a power device, such as a peristaltic pump, to drive the mobile phase through the pipe at a specific flow rate (the pipe can be made from flexible plastic), while the adsorbent is fixed somewhere in the pipe. The mobile phase flowing through the adsorbent should be taken at a certain interval, then detect the component in the taken one.

Following are some related papers, I wish they can help you.

1. Polyethylenimine-functionalized cellulose aerogel beads for efficient dynamic removal of chromium(VI) from aqueous solution, DOI: 10.1039/c7ra09940a

2. Interior multi-cavity/surface engineering of alginate hydrogels with polyethylenimine for highly efficient chromium removal in batch and continuous aqueous systems, DOI: 10.1039/c7ta05679f

3. Function integrated chitosan-based beads with throughout sorption sites and inherent diffusion network for efficient phosphate removal, Article Function integrated chitosan-based beads with throughout sor...