I would require some help from you about how to run a GCMS analysis with XCalibur. Here is my problem :

In the configuration I turned off the auto start for the GC.

1) If I start the sequencewith the auto sample :

- The GC equilibrates

- The autosampler starts and wash the needle

- The GC says ready to inject and then immediately says : waiting for inhibit RDY - It does not wait for the injection and the sequence stops

2) If I start the sequence with the MS :

- The GC equilibrates

- The autosampler starts and wash the needle and get the sample!

- The GC says ready to inject and waiting for closure contact

- The autosampler inject the sample !

but the MS says always ready and never running !

Any idea what to change?

Similar questions and discussions