How can I get the refractive index (n,k) vs. wavelength (300-800nm) of ZnO nanoparticles?

Somayeh Nazerdeylami @Somayeh_Nazerdeylami

11 November 2013 0 3K Report

I am doing an Excel file of (n&k) vs. wavelength of ZnO nanoparticles and TiO2 nanotubes.

Badges
Science topic

LEDs on Vis Light photo degradation of MB water sol via N doped TiO2 in a mini flume?

Good day to all, I have no experience with light emitting diodes. I am building a glass mini flume to demonstrate the photo degradation of Methylene Blue in water running over self cleaning...

26 February 2021 4,026 5 View

Can anyone share his experience regards Smoothing in origin?

I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...

26 February 2021 8,183 3 View

ZnS oxidizes to ZnO!!why??

when I put my ZnS solution in the chemical bath, the ZnS oxidizes so there are ZnO peaks appearing because of the reaction with the oxygen in the air, despite the fact that I close the beaker...

14 February 2021 5,778 9 View

Xrd result of ZnO thin film shown better crystallinity at low temperature and the crystallinity decreases as the temperature increased. why?

I have synthesized ZnO thin films at four different substrate temperature say, 300, 350, 400 and 450C. and the samples were annealed at 450C for half an hour. the xrd result shown better...

04 February 2021 7,641 4 View

What is the minimum centrifugation RPM and minimum time for TiO2 nanoparticle synthesis from plant extract?

In my laboratory, I have an analog centrifuge (does not show real RPM value). Its' brochure indicates the range is 300-3000 RPM. The regulator is marked from 1 to 10. Is there any way to determine...

01 February 2021 2,061 4 View

How to form a shell around a nanostructure core in solution phase synthesis?

Hey, I want to know if I have fabricated some nanostructure and further I want to make a shell on the nanostructure by solution phase method by making it core-shell nanostructure. So, anybody can...

01 February 2021 9,966 4 View

What's the difference between light absorption and coupling in plasmonic metals?

What's the difference between light absorption and coupling in plasmonic metals? It seems that light absorbed in metal nanostructure/nanoparticles doesn't contribute to enhancement in electric...

14 January 2021 1,884 4 View

What is the basis set to optimize ZnO using GaussView for DFT calculation study?

Greetings, I have a bit of problem in setup the basis set of my DFT study for ZnO.. As you can see in the image attached below, I use B3LYP 6-31G (d,p) for geometrical opt. of ZnO.. But sadly, I...

13 January 2021 7,508 4 View

How to study pyridine anchoring mode on TiO2 by ATR?

I want to study the anchoring mode of a pyridine dye on TiO2 nanoparticles. I searched and a lot of papers study that by FTIR using by the attenuated total reflectance (ATR) method. I tried to...

12 January 2021 5,915 3 View

I want to use Gold electrode as a reference electrode for electrodeposition of nanostructures. Can i use it and how ??

How to use a Gold electrode as a reference electrode ??

04 January 2021 4,058 4 View