How can I form a good thin film with Ionic Liquids and also with organic ionic solid compounds?

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

Inquiry on Maximum Nucleic Acid Volume for 2.5 mL Liposome Solution?

I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...

30 July 2024 6,420 1 View

How can I use DFT-D3 correction ( Siesta version 5.0.1)?

Dear Siesta Users, I installed Siesta 5.0.1 and I want to use Grimme's D3 correction. According to the 5.0.1 manual, I could use a few parameters to include the D3 correction in the...

27 July 2024 5,748 0 View

EDC carbodiimide and NHS easter 's half life among different pH?

It has been long known that EDC carbodiimide and NHS easter's half life agains hydrolysis are highly related to pH. However, very surprisingly, not yet found a paper giving a table/chart of their...

25 July 2024 8,738 0 View

Mechanochemistry: ball to powder mass or ball to powder volume?

I run mechanochemical reactions that involves the use of a large amount of catalyst (1:1 molar ratio to the reactant). When I try to understand the effect of amount of catalyst on the reaction, I...

23 July 2024 9,938 1 View

How to eliminate the carry-over effect in GC-MS/MS system?

Hi, I am a PhD student working at Jagiellonian University, Faculty of Chemistry. My work is related to the development of new analytical methods for the quantification of short-chain fatty acids...

22 July 2024 5,492 6 View

MDCI module in Orca software?

Dear Researchers, My question is associated with the "MDCI" method in Orca. Please let me clarify my question using a simple example: Suppose we are going to perform CBS extrapolation using "!...

21 July 2024 1,632 0 View

What are the principles of physical chemistry?

what are the main points

10 July 2024 9,236 5 View

What is the recommended type of pseudopotentials for QE?

Hello dear colleagues and professors Please what is the recommended type of pseudopotentials for QE? ultrasoft or norm conserving?? And from where get all types of pseudos (us, nc, pbe,...

09 July 2024 9,541 5 View

Is there any guidelines about zooming out a chromatogram?

Hi, Just curious to know that in chromatography, a chromatogram should be zoomed to what scale? 10 times of output , 50X or ..? Is there any regulation or general chapter which describes this?...

03 July 2024 3,119 6 View

Mathias Strauss

What surface? What IL? What solid compound?

Iman Omama

surface is glass, ITO, FTO glass and quartz glass. Imidazolium based Ionic liquids and some other derivative of imidazolium based compounds but they are solid

Jhony Orbulescu

Langmuir-Blodgett deposition technique: you will need to make a solution but the solvent will evaporate and an organized film will remain on the substrate.

Can I have any reference for ionic liquids with this technique

J Colloid Interface Sci. 2012 Jun 1;375(1):94-101

Chem. Commun., 2011,47, 10287-10289

J. Phys. Chem. B, 2012, 116 (14), pp 4175–4180

there are plenty...