How can I find that a fabric impregnated with STF(shear thickening fluid ) has saturated?

14 November 2017 1 6K Report

I want to know if adding more STF can affect the performance of my fabric(Increasing energy absorption) and STF max that I can impregnated fabric is how much?

Manigandan Sekar

No it wont affect the performance however the flexibility of the fabric is reduced

Badges
Science topic

More Hosein Hasannezhad's questions See All

How to write an oral history thesis?

I wanted to know what steps should be taken after the interview?

22 June 2024 1,950 2 View

How to make a PMMA coating to be a superhydrophobic surface?

To make a PMMA (Poly(methyl methacrylate)) coating superhydrophobic

08 November 2023 5,895 3 View

How can i inhibit the precipitation of a supersaturation solution of KNO3?

I should prepare a supersaturated stock solution of KNO3 and i did it by dissolving the precalculated amount of KNO3 in boiling water (250g/100ml). Keeping this solution in room temperature...

29 June 2023 1,288 0 View

How to use NDVI MODIS Time Series for deforestation by GEE and creating predictor Deep Learning Model?

Hello, I have a project about deforestation detection using Google Earth Engine as follows: 1)Polygon definition for the protected area of "Yosemite" and "Sequoia" in California, for a period...

27 June 2023 7,829 2 View

Did any study investigate the most accurate and valuable animal response in "Hot plate" specifically in Diabetic neuropathy test?

I Wonder if there is any study to compare different rodent responses validity in "hot plate" test. Thanks A lot

31 January 2023 5,777 0 View

How to reduce disturbances in Coupled Eulerian-Lagrangian (CEL) method?

Hi dears I am simulating the interaction of water with a concrete pool in Eulerian Abaqus (v-2021). -Mechanical behaviour of concrete is CDP and was used Eos (Us-Up) for water. -The solver is the...

08 September 2022 6,428 0 View

Dynamic equation of motion for a mass body when goes around on a sphere surface?

Hello, I want to analyze the dynamic equation of motion for a body going on a sphere surface. However, everything I found is the dynamic equation of motion for a body on a 2D plane, not on a 3d...

04 August 2022 7,314 3 View

Evolutionary Power Spectrum Density of seismic ground motion ?

Hello, Is there any public code to calculate the Evolutionary Power Spectrum Density of a non-stationary signal, such as seismic ground motion?

26 February 2022 3,747 2 View

How to remove EOV from sensor data?

Which data normalization approach can remove EOV effects from time series signals in SHM?

06 July 2021 1,936 3 View

How to calculate cellZone area in OpenFOAM?

Dear Foamers I have a 2D case of a reciprocating engine simulation, and the mesh is of moving type and the area of cylinder keeps changing. Since the cylinder geometry is complex, and for further...

14 June 2021 3,780 2 View

How to develop investments in renewable energy sources?

08 August 2024 5,112 3 View

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

How can I add own Henry coefficients in Aspen Plus?

Hi, i would like to simulate an absorption process in Aspen Plus. I want to use the NRTL model und would like to add some individual Henry coefficients. Is that possible and how?

05 August 2024 2,333 2 View

Why is TLC not a form of partition chromatography?

Why is TLC not a form of partition chromatography and paper chromatography not a form of absorption chromatography?

03 August 2024 7,035 3 View

¿Are oxygen vacancies in semiconductors capable to change the band gap?

Dear all! Oxygen vacancies do raise negatively the Fermi level by increasing the negative charge in the semiconductor crystal structure. In the case of n-type semiconductors, I wonder if this...

30 July 2024 8,339 2 View

Is artifacts in XPS possible to build high deviation in binding energy larger than 5 eV??

Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...

30 July 2024 9,824 2 View

How to make the concentration measurements for the hydrogen absorption/desorption in the metal hydride?

Hello Everyone! I am trying to create a metal hydride system where I am trying to create a temperature control with the emphasis on measuring the concentration of the hydrogen with the hydrogen...

29 July 2024 7,577 2 View

CAD File of human's & rat's respiratory airways ?

Dear all, I am working on particle deposition in human's & rat's respiratory airways using CFD and I am looking for the 3D CAD file for my simulations (STEP or IGES format). If somone has such...

29 July 2024 1,092 2 View

Is there a database with onshore wind production for the wind farms in Portugal?

I am looking to predict some production for future onshore wind energy production in Portugal, is there any database with info of performances of the existing wind farms in the country? something...

28 July 2024 1,750 1 View

HAs anyone used TGA to find activation enegy of water evaporation?

I have different polymer solutions and I hypothesize that water molecules are retained based on the water-polymer interactions, so the amount of free water is less to intercat with drug tablet....

28 July 2024 9,545 6 View