I have done a 2D solid body simulation using a half of domain (right side) to save time and I have got results. However, I want to display the full sample results (left side +right side). Therefore, I need your help to find out how I could do it in ANSYS 16.2. Thanks in advance.
Soroush Papari
Hi
when your geometry is Symmetric so you can use symmetry boundary. all result are Same in both sides of model. but ANSYS simulation half it, so software can not display the full model. I offer ,you can display all result of half model for the other side, it work is right, fully. or you can simulation full geometry, but speed of run is low.
ANSYS can display results that it simulate the part of geometry
Good luck!
0 votes
0 thanks
- Badges
- Science topic
- Similar topics
- Theoretical Physics
- Time
More Zuhair Kadhim Jahanger's questions See All
Similar questions and discussions