How can I change units in TGA (unit conversion in dTG) ?

More Gamzenur Özsin's questions See All

What is the most reliable technique to determine the voltage range for the galvanostatic charge-discharge tests of composite electrodes?

What is the most reliable technique to determine the voltage range for the galvanostatic charge-discharge tests of composite electrodes for Na-ion half and full cells?

23 August 2023 493 1 View

HAs anyone used TGA to find activation enegy of water evaporation?

I have different polymer solutions and I hypothesize that water molecules are retained based on the water-polymer interactions, so the amount of free water is less to intercat with drug tablet....

28 July 2024 9,545 6 View

What is the degassing temperature and time for biochar for BET surface area analysis if TGA is not possible?

Since BET and TGA both are very costly instruments and many places the facilities are not available (for large number of samples) hence a threshold degassing temperature and time is preferable

16 July 2024 8,112 2 View

How calculate the conversion alph from tga analysis?

I read it Convert the y-axis from mass loss to degree of conversion (100-x)%. What if tga analysis have residual char, for example at mass loss% 27% Is it the same eqation to get conversion...

15 July 2024 4,218 1 View

Can anyone let me know can TGA can be performed without using purged gas, just in normal atmospheres?

Usually TGA is performed either with Nitrogen or air which are purged through the system. Can this analysis be performed without using any of these purged gases? Also for air (80/20) is set by...

30 May 2024 7,679 3 View

Can anyone explain how to determine degassing temperature and time for biosynthesized nanomaterial for BET analysis?

I have also attached TGA and DSC analysis of biosynthesised nanomaterial.

30 May 2024 1,565 1 View

Could someone help a right procedure for TGA analysis of cement?

I analyzed cement samples exposed and unexposed to moisture over various periods. The TGA results of these samples showed variation with each repetition. However, I consistently used calcium...

22 May 2024 1,339 3 View

What temperature is needed to eliminate carbon from the catalyst through calcination?

I have to calculate the carbon content present in the catalyst from the TGA plot. Does anybody have an idea?

17 April 2024 4,718 2 View

How to set reaction rates In COMSOL?

Hello I'm using COMSOL 6.1 Reaction engineering module. I'm modeling a reaction in the form of : A-->B+C+D+... the reaction describes the thermal decomposition of a solid material. I got the...

16 April 2024 5,672 3 View

Is possible to desorbe CO2, N2 or water in ZIF-8 between 30ºC and 60ºC?

Dear all, After checking DSC and TGA analysis for ZIF-8 samples, it was possible to observe an endotermic peak at around 50ºC, using DSC under N2, and a weight loss in TGA at around 38ºC and 125ºC...

04 April 2024 8,460 4 View

Why does the thermal decomposition beavior (TGA temperature) of propylene carbonate is much lower than its boiling point?

We are recently studying a materials containing propylene carbonate (PC) as co-solvent. And the TGA results show it started to decompose below 200 C (~110 -150 C). When we analyzed each components...

02 April 2024 5,942 0 View

Matthias Jaunich

Hello,

what about:

calculating the percentage in the numerator by:

mass lost divided by the Initial mass and multiplied by 100%

and

calculating the denominator by multiplying by the heating rate?

This should give you a reasonable result but please check this again.

regards

Thank you Mr. Höhne,

this is much more convenient.

Ashraf Muhammad

Sir Hohne, it is not working