Hi dear,
I need plot 2D graph between an input impedance with a tuning stub length or a prob feed position by using the CST program.
Sincerely,
For sure you can monitor this from the Z-parameters as the real part of it.
Hi my doctor,
Thank you so much for your interest.
In this case, I must make a parameter study and collect the results after that draw these results.
Yes, and you can add that from the micro/ results
liked, I will try it.
Dears, merry Chrismas, What is the different between IEEE (Gain) and Realized Gain of an antenna in CST? Sincerely, Hayder S. Ahmed
11 December 2016 8,139 7 View
07 August 2016 4,545 2 View
07 August 2016 6,040 11 View
05 June 2016 5,401 10 View
03 April 2016 2,495 4 View
02 March 2016 5,532 2 View
10 November 2015 2,539 0 View
10 November 2015 6,260 0 View
Results of single-case research designs (i.e., n-of-1 trials) are often evaluated by visually inspecting the time-series graph and computing quantitative indices. A question our research team is...
03 March 2021 687 1 View
This is a Buck (step-down) Converter and I am new to this program. I need to program with simplified C block and I actually don't know what to do. Can anyone show me how to do this? Or at least...
02 March 2021 8,233 1 View
im working now on TPV solar cells and metamaterials and i realy need our help in CST microwave i have a tpv cell simulation and i want to extract particullarly the absorbtion of only the active...
02 March 2021 2,246 2 View
For my research i will need to measure plant quantitative traits (especially leaves area and roots length, but would be nice to add some more information). I recently discovered...
01 March 2021 5,035 2 View
I have designed reflectarray element to generate OAM beams at 5.8GHz and feeding it though Horn Antenna on HFSS. After full wave simulation, i am not getting desired results i.e Radiation pattern...
01 March 2021 9,701 5 View
I want to make a stacked bar graph with showing each data value as dots. I tried with graph pad prism, version 6, but could not succeed. Does anyone have tried before making such graphs?
01 March 2021 9,383 1 View
I am aiming to determine the ADC values of a commercial fish feed, but I do not have a steam pelleter or extruder available to me. Ideally, the pellets could be coated with some inert marker....
28 February 2021 7,967 3 View
Hi researchers, I am searching for some accurate way to do the circuit modeling of planar CPW-fed monopole antennas. I have gone through the literature where mostly circuit modeling is done using...
28 February 2021 7,016 1 View
Hello everybody! I have a problem with developing a compact antenna for the 1MHz-5MHz frequency range. Tell me what type of antenna can be used and what books and articles to read to perform this...
27 February 2021 7,710 4 View
I am simulating helix antenna in hfss, right now, giving excitation with 50 ohms port. When I see the results of Z parameter (real). It shows lower than 50 ohms. Do not understand, if it can be...
27 February 2021 4,218 7 View