https://www.simutechgroup.com/tips-and-tricks/fea-articles/97-fea-tips-tricks-thermal-transient
Dear Rafsan, thanks for your reply.But i want the answer in cst as i don't use Ansys and many papers use only cst in their results and didn't need Ansys.
Hi Maha,
Bit late answering this, but in case you are still having troubles.
There could be three reasons for not getting the results:
1) You need to give the input signal a pulse. I tend to use a rectangular signal.
2) You need to change the simulation duration in the solver setup window.
3) Make sure that your units are set to (s) I usually have mine on (ns) and this has caught me out a few times.
If you have tried both of these and are sill having issues please don't hesitate to get in touch
Hope this helps.
Shaun
- Badges
- Science topic