How can I achieve a connection between a glass luer tip syringe and PTFE tubing (0.58 mm ID and 1/16 in OD)?

More Kavnen Tseke's questions See All

Free DFT software for B3LYP and wB97xd calculations of small organic molecules?

Can anyone suggest a free and easy to use computational software ideal for carrying out calculations on organic molecules? Most organic chemistry literature reports I've seen use Gaussian or...

10 November 2019 8,178 2 View

What thickness need for ITO to use as conductive layer?

I want to do RF sputtering of ITO on glass substrate using magnetron sputtering. what thickness do i need to make it good conductive layer to use it for PSC. Moreover, whats about thickness of...

01 March 2021 395 3 View

Glass fiber content in a gypsum board ?

Any idea on how to get the volumic ratio of glass fiber in a gypsum board ? Thank you for your help !

01 March 2021 2,501 3 View

Concrete compressive strength databases?

I am looking for datasets similar to this one: http://archive.ics.uci.edu/ml/datasets/Concrete+Compressive+Strength I am looking for concretes with different types of aggregates (Recycled,...

27 February 2021 6,801 3 View

How to properly calculate the fluid solid heat transfer between polypropylene matrix and glass fiber in a porous medium?

I'm building a cfx model of thermoplastic pultrusion process on ansys and i have a doubt on how is the proper way to set this parameter in a porous medium

24 February 2021 1,915 1 View

Have you ever experiencing air vent trouble in fermentation process?

Dear all, My research group is currently working with a 12-litre fermenter. Somehow, if we do the fermentation for more than 20 hours, the process will be more prone to contamination. Our current...

23 February 2021 1,908 2 View

How to properly calculate Interfacial area density in a porous domain?which are possible value for glass fiber?

I'm doing a cfx simulation of a multiphase flow in pultrusion and i set the Interfacial Area density in the heat exchange of a porous medium in this way IAD=Total fiber lateral surface of fiber...

23 February 2021 6,043 1 View

How can I measure the thickness of thin layers deposited on textured glass susbtrates?

I want to measure the thickness of aluminum oxide and titanium oxide layers deposited on textured glass substates. The layer thicknesses are typically below 100nm.

21 February 2021 5,465 4 View

How can I measure the surface interaction or surface interfacial chemistry between polishing abrasives and upper surface of substrate ?

I am working on polishing abrasives. I need to do few characterizations ? which can provide the on time surface chemistry of substrate with polishing abrasive during optical polishing. I would...

18 February 2021 5,319 3 View

No title

The regenerated cellulose film was prepared by zinc chloride/H2O system. The zinc chloride had been washed away in the regeneration process, and the wet film which was not dried had uniform...

18 February 2021 9,538 1 View

Which is the best silane for making a borosilicate glass surface hydrophobic permanently? and what is the protocol?

Regarding my needs I am looking for a glass coating agent that makes the glass hydrophobic permanently

09 February 2021 3,924 5 View

Peter Farrington

https://www.meddeviceonline.com/doc/upchurch-scientific-introduces-capillary-luer-0001

Kavnen Tseke

Many thanks Peter. I'm wondering if the bio-compatible adaptor would be ideal for microchip reactions and compatible with chemical solvents

Talk to the vendor to confirm the solvent resistance of the components before you purchase. PEEK and Tefzel are resistent to most common solvents.