03 September 2023 1 5K Report

anyone here has any idea about the material polarization method mentioned here ?

More Manisha Sukhraj Kothari's questions See All
How to calculate percentage cumulative drug release?

How to calculate percentage cumulative drug release when, Total volume of dissolution media = 250ml Added formulation was equivalent to 10mg of drug Sample withdrawn = 1ml each time Sink condition...

15 July 2024 4,192 1 View

How can we recover Iron or acid from industrial waste water, pH of waste water is approximately 2 ?

Steel processing industry releases waste water, which contains 20% of Iron with 2 pH. can you suggest any low-cost technique to separate or recover anyone, either acid or Fe from the waste water, pls

24 April 2024 5,636 6 View

Can someone please explain the reason of these globular structures on top of my HeLa cultures?

These structures aren't present in the regular cultures but appear suddenly after we do Biotin labelling. We have performed this experiment earlier but these structures started appearing just...

17 March 2024 6,021 0 View

OCP measurement in corrosion study?

When OCP stabilizes in a given electrolyte there is formation of passivation layer on sample surface or it shows that at this potential corrosion occurs. Also my tafel Ecorr values are not comming...

04 February 2024 8,735 2 View

What is the median discharge voltage for any energy storage device?

What is the median discharge voltage for any energy storage device?

04 February 2024 8,068 1 View

Why the colombic efficiency of supercapacitor device initial decreases then increase for 1000 cycles of charge discharge?

why the colombic efficiency of supercapacitor device initial decreases then increase for 1000 cycles of charge discharge?

03 February 2024 281 2 View

How to find the electronic conductivities of powder samples?

How to find the electronic conductivities of powder samples?

17 January 2024 184 2 View

Can anyone help me , how i can export data points after reitveld refinement using MAUD (Material Analysis Using Diffraction) software ?

I have done reitveld refinement of my material using MAUD, and getting the image of the refined XRD, I also want to extract its data points as well. Is it possible to get these data points in...

16 December 2023 2,842 0 View

How to create GGA DFT input file with PW91 Functional in Gaussian16?

Explain in detail with example.

29 November 2023 5,960 2 View

Swing-bucket rotor for AAV iodixanol gradient ultracentrifuge?

Hi all, I'm starting to work with AAV. The protocol that I follow purify AAV by iodixanol gradient ultracentrifuge. The rotor that the protocol recommended is VTi 65.2 Vertical-Tube Rotor....

02 October 2023 3,392 0 View

Similar questions and discussions
How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

What is the right voltage sweep direction for characterization of HER kinetics?

In general, when performing a Tafel analysis for corrosion resistance measurements, a line voltage scan is performed from say -250 to +250 mV vs. OCV at low scan speed around 0.125 mV/s. However,...

25 July 2024 7,982 3 View

What is co-polarization and cross polarization? How can plot it from CST studio?

what is co-polarization and cross polarization? How can plot it from CST studio? what are steps and process for find out co-polarization and cross polarization from CST studio?

08 July 2024 7,869 1 View

How to calculate corrosion rate from potentiodynamic polarization test data for dissimilar welds?

we need surface area, corrosion current, equivalent weight and density of the metal involved for corrosion rate calculation in mm/year (lets say). For dissimilar metal welds, how can we measure...

30 June 2024 5,943 2 View

How to Compare Tafel plots in different KOH concentration?

I have to compare overpotential and current density of different materials from tafel plots. These tafel plots have obtained in different concentrations of aqueous solution. How do I compare these...

24 June 2024 6,399 2 View

How often should I change media for RAW 264.7 cell cytokine analysis?

I am currently working on a study using RAW 264.7 cells. I am polarizing the cells to an M1 phenotype. I am then applying an anti-inflammatory compound 24 hours later. These cultures are being...

09 June 2024 867 1 View

Charge transfer resistance (Rct) from polarisation curves and impedance (Nyquist diagrams).?

Hi, every one we are now carrying out some experiments on the corrosion resistance in NaCl 0,60M of zinc - nickel alloy on stainless steel by electrochemical impedance spectroscopy and by...

29 May 2024 4,488 0 View

Can we use the approach of studying political polarization to study gender opposition?

Hi all RG users, there are a wealth of research referring to the political polarization, like linguistic divergence, affective polarization etc. Then, is it meaningful to study gender opposition...

22 May 2024 3,273 2 View

DFT calculation method to enhance the speed of spin polarization?

I attempted calculations for hydrogen adsorption on transition metal-doped g-C3N4. I want to know if it is possible to perform geometry optimization without enabling spin polarization, and then...

19 May 2024 3,318 7 View

Why my simulation of Mixedmode is always wrong?

I want to make n-type and p-type GaN devices as inverters and simulate them by Mixedmode. However, it always turns out to be wrong. With the warning: no solution possible. I want to know what the...

12 May 2024 4,377 1 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close