Have A grade of glass microfiber filters (GF/A) been used as Na ion battery separator?

More Hamideh Kashani's questions See All

How to approach CFD simulation results of a flow past a cylinder?

Hi all, I'm doing a transient simulation of flow past a rectangular cylinder close to the free surface. As far as I'm concerned, the common practice is to discard the initial stages of the...

25 February 2021 1,348 3 View

How to calculate time-averaged fields from Ansys CFX solver?

I would appreciate any comments on the following problem. I need to calculate mean fields (e.g. pressure, velocity and vorticity), for which I activate Trn Stats tab in CFX-Pre. However, what I...

21 February 2021 8,548 7 View

The most suitable turbulent models to predict flow past a floating body?

Hi all, I'm planning to simulate flow past a floating body using CFD method with the main purpose of investigating its stability against hydrodynamic forces. A sketch of the problem is presented...

28 January 2021 5,872 5 View

Can anybody suggest me a cheap material for surface modification of hydrophilic Titania nanoparticles?

I'm looking for a cheap material to modify Titania nanoparticles in order to use them in polymer and increase its contact angle.

13 December 2020 504 5 View

How to measure the equivalent sand-grain roughness of a sandpaper?

I want to use standard sandpapers of different grit sizes to impart flow resistance to a surface. I am wondering how to convert the roughness of sandpaper to an equivalent sand-grain roughness. Is...

18 October 2020 9,384 3 View

About designing of packed column?

i want to design a packed column via aspen plus. is there any law to determine the L/V in any stage? for example for any stage, is necessary the L/V ratio be more than 70-80%?

27 August 2020 8,127 3 View

How to interpret arima model with regressors in r?

Hi there; I need to produce such an equation for a time series using arima model: y(t) = y(t-1) + a*x(t) + b*x(t-1) I know if I use for example arima (1,0,0) with x as the exogenous...

07 August 2020 7,438 6 View

Why some use seasonal ARIMA(p,d,q) (P,D, Q) instead of SARIMA?

Hello everyone. I am trying to use ARIMA model for a time series with seasonality. As I am new to this topic, I use the internet as my guide. My question is why anyone should use Seasonal ARIMA...

05 August 2020 219 4 View

Why does a turbulent flow form eddies?

I can't understand from a physical standpoint how fluctuating velocity components in a turbulent flow lead to formation of spinning structures of different sizes known as eddies. Can anyone...

19 June 2020 549 68 View

How to examine the stability of an airfoil?

In the problem of my interest, an airfoil is subjected to fluctuating flow forces associated with vortex shedding. The objective is to examine airfoil stability. In the literature, I saw drag and...

18 May 2020 5,317 1 View

How to size battery banks?

I am designing a small grid connected solar PV power-plant. As the battery's capacity is specified in Ah and demand in kWh. What is the best way to size the battery bank? I have battery price in...

28 February 2021 1,638 3 View

How to model the battery pack in PSIM or PSCAD?

Hello, I have simulated a single battery cell using Thevenin equivalent circuit. For a battery pack, I have a large number of cells connected in series and parallel connections. Is there any way...

28 February 2021 2,116 1 View

How to calculate battery consumption for IoT device?

Hi, everyone I'm working on a privacy-preserving algorithm that will apply to IoT devices. So, I need to measure the power consumption by implementing this algorithm. Any suggestion, advice,...

25 February 2021 8,749 6 View

How to delaminate copper in water-based anodes?

Hello everyone, I'm looking for a way to delaminate copper current collector of water-based anodes in Li-ion batteries without damaging the graphite film. I tried different materials such as HNO3...

24 February 2021 3,785 3 View

What is the difference between AC conductivity and DC conductivity? Is AC conductivity = ionic and DC conductivity = electronic?

I am reading papers on batteries and although mostly people have reported ionic conductivity in Scm-1 but some have reported DC conductivity as well I and am confused as to what that is. Any help...

21 February 2021 9,207 6 View

Where can the fault diagnosis data set of lithium battery be found?

Most of the data sets on the network only contain good information about the voltage and internal resistance of lithium batteries. The data of faulty battery is missing. Who can help me, I will be...

21 February 2021 8,659 1 View

Not able to charge-discharge Li-ion coin cell at higher C rate ?

I am working on cathode material. I have made different Li-ion coin cell against Li metal using commercial available cathode materials such as LCO,LMO, LFP and NMC and also with the lab...

18 February 2021 1,450 3 View

Is there a paper that shows the effect of the thermal conductivity of solid electrolytes on lithium secondary batteries?

I want to know the effect of thermal conductivity characteristics of solid electrolytes on the all-solid battery, but I don't know which paper to refer to. Is there a paper on thermal behavior?

15 February 2021 8,806 2 View

Why the battery connected on the load side for storing purpose is taking the volatge /current at whatever rating it is given in matlab simulation?

I am designing a DAB DC DC Converter and when I am connecting a battery block in Matlab and fix its specification lets say 350 V and 25 A, when I am giving input as 600V, Battery would charge to...

11 February 2021 3,110 1 View

How to get actual or true SoC while predicting SoC for Batteries using Data Driven Approaches?

I have seen it in multiple research articles that authors use certain approaches to predict electric vehicle battery's state of charge(SoC) and then they compare it with battery's true SoC. So I...

11 February 2021 9,070 3 View