are there any researchers working on the extensibility of the Noxim simulator?
follow
Is it possible to simulate a heterogeneous 3D architecture with Noxim simulator ??
01 February 2019 3,948 2 View
Is it possible to simulate a heterogeneous 3D architecture with GEM5 simulator ?? how can we create a layer of memories and a layer of processors ?
01 February 2019 8,238 1 View
Dear RG colleagues, what do you think about publishing books on https://www.editions-ue.com/ Best Regards
07 August 2018 3,374 3 View
Dear RG Researchers, how can we measure the impact of the quality of work on RG? H index? I think that the score on RG is not directly related to the quality of the publications? are there any...
06 July 2018 2,920 5 View
Dear RG researchers, Is it better to publishin conferences or journals? Best Regards
06 July 2018 4,570 4 View
Dear RG colleagues, What is the Emerging Sources Citation Index? and the difference with web of science? Best Regards
06 July 2018 1,836 0 View
hello; I run the linux kernel for armv8 in gem5 on fs_big.LITTLE mode, I used the following command: ./build/ARM/gem5.opt configs / example / arm / fs_bigLITTLE.py --cache --kernel = / media / ali...
05 June 2018 5,039 1 View
is there a real-time simulator for networks-on-a-chip?
05 June 2018 4,868 1 View
01 January 1970 918 2 View
Are there researchers working on water management in agriculture? especially on the tools to use for the development of intelligent platforms?
01 January 1970 7,282 7 View
Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...
01 March 2021 9,332 6 View
Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...
28 February 2021 400 1 View
Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks
24 February 2021 9,378 3 View
I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....
24 February 2021 4,428 3 View
Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...
24 February 2021 1,598 2 View
Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...
23 February 2021 1,761 1 View
Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...
22 February 2021 4,882 3 View
For my research, I would like to simulate an end to end 5G network. My goal is to observe the behaviour of SDAP protocol, dynamic configuration of 5QI values etc. To summarize I would like to...
21 February 2021 7,624 3 View
Dear Research Gaters, Let me first add context to the question. I am looking to simulate the waste management system and resources of a city. The hardware devices I need to simulate include,...
21 February 2021 2,333 4 View
I need to simulate the optical properties of a biomaterial, namely DNA, in COMSOL. Basically I need to simulate the IR absorption spectrum of a cylinder filled with a 'concentration' of DNA. I am...
21 February 2021 3,043 3 View