Which tools can be used to generate machine codes for additive manufacturing?
02 March 2021 7,220 2 View
I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....
24 February 2021 4,428 3 View
Dear distinguish professors and scholars, I have a research in measuring two kinds: think tank capacity and research impact on policy. Can I do two kinds of mixed methods in order to find, "Is...
20 February 2021 6,897 1 View
I want Researchers from Educational Measurement and Evaluation, relating to teaching, learning , academic performance and test validation
18 February 2021 4,757 13 View
I've got this 5 year Direct Normal Irradiance data I downloaded from https://re.jrc.ec.europa.eu/. I ordered this by year and by every 24 hours because I need the DNI curve by max in summer, min...
17 February 2021 2,777 5 View
Dear colleagues We are exploring possible data collection methods for environment and behavior research in the context of architectural environments. Have you conducted any Post Occupancy...
16 February 2021 2,575 4 View
Most of the references I found were on the economic productivity in agriculture but very limited application in manufacturing sector. I would appreciate if anyone could share the references on...
15 February 2021 8,342 7 View
Hello, I have a question regarding non-parametric alternatives for a RM-ANOVA. In my study I had two groups that were measured on two timepoints (pre-post measurements only). I was planning to...
11 February 2021 8,599 7 View
I have 2 concentration time curves of a subcut drug implant. the first group has a peak around the 50 day mark where as the second group does not. Both groups received the same implant by the same...
10 February 2021 2,305 3 View
Hi I've been looking for a stat package for my sensory evaluation data (progressive profiled which is a multi-timepoint version of descriptive analysis). Is there any available one to...
08 February 2021 9,170 3 View
